AE Owner’s Manual
PACKING CHECKLIST
Your Billy Goat is shipped from the factory in one carton, completely assembled except for the upper handle assembly, and lift rod.
READ all safety instructions before assembling unit. TAKE CAUTION when removing the unit from the box.
PUT OIL IN ENGINE BEFORE STARTING
PARTS BAG &
LITERATURE ASSY
Warranty card P/N- 400972, Owner’s Manual
| 48 | FILL WITH |
|
| |
47 |
| WATER ONLY! |
1182
83
52
46
82
Boxing Parts
Checklist
Owner’s Manual
AE 360251
Engine Manual Per
Model
Honda 4.0 HP
B&S 5.5 HP
ASSEMBLY
1. HONDA: Unfold the upper handle (item 48) and slide handle lock loops (item 118) into place to secure the upper handle to the lower handle (item 82 & 83).
1.BRIGGS Remove the bolts and nuts that are shipped in the upper handle. While holding the lock loops on the handle use the bolts and nuts removed above to attach the upper handle to the hinge bracket on the lower handles and tighten nut against the bracket. NOTE: DO NOT over tighten. The handle should be free to rotate for folding.
2.PIVOT the lift rod (item 46), insert the pin through the lift handle (item 52) then lock in place with lynch pin (item 47). Repeat same steps on other side.
3.FILL the water tank (item 2) to desired weight with water ONLY.
4.CHECK engine oil level and fill to proper level. Also check oil in gear reduction reservoir and fill if necessary. See engine owner’s manual for type and amount of oil to use. Move the tine engagement lever to the down position, to level engine during checking.
5.CONNECT spark plug wire. Set the engine stop switch to the ON position. You will use the stop switch on the handle during operation.
Part No 360251 | 7 | Form No F071206A |