Operating Instructions

4	L E S 6 0 0 O P E R A T I N G I N S T R U C T I O N S

Step 1 Power for Your LES 600 Receiver/Amplifier

1Check that:

•Both front panel microphone volume controls (MIC 1 VOLUME and MIC 2 VOLUME) are set to minimum (turned fully counter-clockwise).

•The Receiver/Amplifier is connected to a power source: Use the enclosed AC/DC power adapter to plug into a power cord or a standard wall electrical outlet, and connect the other end to the DC POWER IN jack on the back panel.

•The speakers are connected as instructed in the Installation Guide included in your packing box.

2Turn ON the MIC 1 VOLUME power/volume knob located

on the left side of the front panel of the Receiver/Amplifier.

		The red POWER light on the top left
	Note Refer to the	should light up. (If your system has
	Reference Guide on page	the optional additional wireless mod-
	14 to identify the name and	ule installed, you may turn the Mic 2
	location of each component	Volume power/volume knob on as
	of your system.	well. This knob is located on the right
	Familiarizing yourself with	well. This knob is located on the right
	Familiarizing yourself with	side of the front panel and has its own
	these pages may be helpful	side of the front panel and has its own
	these pages may be helpful	POWER light on the top right that
	if you are unfamiliar with	POWER light on the top right that
	if you are unfamiliar with	will light up.)
	electronic equipment.	will light up.)
	electronic equipment.