USING THE T31 TRANSMITTER
The T31 Transmitter’s microphone cord is the transmitting antenna. Do not bunch up the cord or wrap it around the transmitter. For maximum range, the cord should hang as straight as possible. The transmitter can be placed in a pants pocket, or clipped onto a belt or waist- band. Make sure the transmitter is turned OFF when not in use.
1.Make sure there are two charged AA batteries in the transmitter. If batteries are not installed, see the section Battery Information on page 10.
FIG. 3: T31 TRANSMITTER TOP VIEW
Mic | Off | On |
Mic | FM | On/Off Switch |
Jack | Mic | Mic Mute Switch |
|
Williams Sound FM
2.Plug the microphone cord into the “Mic” jack on top of the Transmitter.
3.Place the transmitter in the belt clip case provided.
4.Turn the power switch on top of the transmitter to “On.”
5.Clip the microphone onto a collar, lapel, or tie. It should be as close to the speaker’s mouth as is practical. (See Figure 4.)
FIGURE 4: CORRECT MICROPHONE PLACEMENT
Yes |
| Yes |
| No |
The SoundFocus System 300/400 comes with an omnidirectional,
6.Turn the Mic Mute Switch to “On” when you are ready to speak. This switch allows you to mute your microphone without turning off the transmitter. Listeners cannot hear you through the system, and also do not hear the noise present when only the receiver is on.
6 | Williams Sound ® |
Helping People Hear