Krell Industries 505 manual Remote Control Description, Battery Installation and Removal

(SECTION THREE: Anatomy of the Evolution 505 continued)

Remote Control Description

See Figure 2 on the previous page

The Evolution 505 remote control provides the same functions as the front panel. In addition, there are three keys that are unique to the remote control, and these are described below.

22 Repeat Key

Replays selected track until new feature is selected. See also, Using the Repeat Key, on page 27.

23 Repeat A-B Key

Creates a loop between two pre-determined points within a single track or sequential tracks. Press once to select the start of the repeat loop (A), and press again to select the end of the loop (B). See also, Using the Repeat A/B Key, on page 27.

24 Audio Key

Cycles between the stereo and multi-channel layers of an SACD disc.

The following remote control keys are not operational:

setup, disc, subt, angle, and ret.

Battery Installation and Removal

The remote control uses 2 AAA-size 1.5 Volt batteries. Batteries are included with the shipment. To install the batteries:

1.Remove the remote control backplate, using the supplied T-10 Torx wrench.

2.Install the batteries, following the battery position diagram on the plastic battery receptacle.

3.Replace and secure the backplate.

Note

Replace batteries when remote control function becomes intermittent.

Do not use a knife or other sharp object to remove the backplate, as this may damage the remote control finish.

Remove batteries if the remote control is not used for a long period of time. Battery leakage can damage the remote control.