American Standard 3232.ST, 3636.ST Cleaning and Maintenance, With reasonable care and maintenance

1 Insure the floor and stud walls are square and plumb. Provide a 5" x 5" (127mm x 127mm) opening in the floor for the drain (see Figs. A & B). The drain plug accom-modates a 2" (51mm) PVC waste pipe. The waste pipe should extend above the surface of the sub-floor, refer to chart on page 2 for the required dimensions. See product drawings on this page for the specified drain locations.

4 After the bedding material has been poured and before it sets, lower the shower base into position with the drain assembly sliding over the waste pipe as shown in Fig. E. It will be necessary to "rock" the shower base until the top of the tile flange aligns

3636.NEO, 3838.NEO, 4242.NEO
90°	C/L	C/L	90°
	6-5/8		6-5/8
	51 mm (2)	127mmx127mm
PVC Waste Pipe
			(5x5) Opening
A (See Product Chart for Drain Location)

3232.ST, 3636.ST, 4242ST, 6034.ST, 4834.ST, 4832.ST
	6-5/8		90°
	90°
	51 mm (2)	C/L	127mmx127mm
B	PVC Waste Pipe		(5x5) Opening
	(See Product Chart for Drain Location)

with the lines drawn in Step 3 on the stud walls. Make certain the apron is contacting the rough floor along the entire length of the shower base. Insure that the base is level in two directions (see Fig. F). Snap strainer back into place and check for proper drainage.

Level

Level

Note: Variations in levelness of the subfloor may require adjustment of waste pipe height.

*For 6032.STRH and 6032.STLH, see drawing for proper location of 5" x 5" drain cut-out.

SHOWER BASE	WASTE PIPE HEIGHT
3636.NEO	5/16" ± 1/16"
3838.NEO	3/8"	± 1/16"
4242.NEO	5/16" ± 1/16"
3232.ST	3/8"	± 1/16"
4834.ST	1/4"	± 1/16"
6034.ST	1/4"	± 1/16"
3636.ST	1/4"	± 1/16"
4242.ST	5/16" ± 1/16"
4832.ST	1/2" ± 1/16"
6032.STRH/LH*	1/2" ± 1/16"

FLevel base in two directions.

5 Secure the base to the studs as shown, using the screws and the brackets provided. See Fig. G. Note: Allow the bedding material to completely harden before applying weight to the bottom of the shower base.

Base Flange
Drywall	Bracket
Screw

2	DRAIN		Strainer
	ASSEMBLY	Rubber
		Caulking
		Gasket
Before installing drain into
the shower base, remove		Drain
strainer (see Fig. C). This		Body
will be installed after		Silicone	Shower
shower base is in its final		Sealant	Base
position. Install the drain to
the shower base as shown		Rubber	Fiber
in Fig. D. Use silicone
		Gasket	Gasket
sealant between drain
body and shower base.			Locking
			Nut

	C
		Waterproof
		Drywall	3 mm
		13mm (1/2")
			(1/8)
		minimum
No Bedding
	Bedding Material Area
Under
Apron
159mm
(6-5/8)
Bedding		51 mm (2)
		PVC Pipe	51x102 mm
Material
	127 mm (5)
D			(2x4) Stud Wall

Stud

Shower

Base

G

6	Tape over the strainer to protect the finish
	and prevent construction debris from
	entering the drain.
	Finish installation as shown in Figure H.
			Tile
		Caulk	Waterproof
			Drywall
			Tile
			Adhesive
			Bracket
			Stud
		Shower	Splash
			Lip
	H	Base	Flange

3	Draw a line 6-5/8" (159mm) from the			CLEANING AND MAINTENANCE
				Your American Standard shower base is designed to last indefinitely
	sub-floor on to the studs at each
	side of the opening. Using this line			with reasonable care and maintenance.
				The high-gloss acrylic surface is resistant to impact and retains its luster
	and a level, mark the remaining
	studs. (See Figs. A & B.) This will be			with proper care and maintenance. An integral, slip-resistant surface is
	the installed height of the shower			incorporated for user safety.
	base. Mix the low-shrink bedding			General Cleaning: Do not use abrasive cleaners; a mixture of warm
	material (grout, mortar, plaster, etc.).			water and a mild liquid detergent is adequate for most cleaning. Strong
	Concrete is not recommended.			detergents formulated for use on tile or porcelain-enamel surfaces
				should be avoided.
	Apply enough bedding material to
				Caution: Do not allow liquid detergent containers to remain on base
	support the entire bottom of the
	shower base. The bedding material	E	Lift and lower base over center	surfaces for more than a few moments. Do not use Lestoil, Windex, Mr.
			of drain pipe and set into place	Clean, Dow Disinfectant (spray or concentrate), or Lysol Basin, Tub and
	must not be used under the apron
				Tile Cleaner. Do not allow nail polish remover, dry cleaning fluid, acetone,
	(front edge).
				paint remover, or other solvents to contact acrylic surface.
FOR AFTER-SALES SERVICE CALL 1 (800) 442-1902 WEEKDAYS.				751817-100 Rev. Q
© A S A m e r i c a , I n c . 2 0 0 8