American Standard T010.5XX Adjust HOT Limit Stop HOT Limit Safety Stop Adjustment, Service

3ADJUST HOT LIMIT STOP

HOT LIMIT SAFETY STOP ADJUSTMENT
By restricting handle rotation and limiting the amount
of hot water allowed to mix with the cold, the HOT LIMIT
SAFETY STOP reduces risk of accidental scalding. To set
the maximum hot water temperature of your faucets, all
you need to do is adjust the setting on the HOT LIMIT	1
SAFETY STOP.

"RED RING"- HOT LIMIT SAFETY STOP

Use a flat blade screwdriver or your fingers to pull up and rotate red HOT LIMIT SAFETY STOP (1). Follow Step "A" or "B" to adjust min./max. discharge temperature. "0" being the hottest to "7" the coldest temperature setting. Factory set at "0".

"A"

"A"

ADJUSTMENT WHEN WATER IS TOO HOT

PRY RED RING

FORWARD AND ROTATE COUNTER-CLOCKWISE ONE CLICK

5

0 1 2 3 4

TEMPERATURE

SETTING

NUMBERS

6

"B" "B"

ADJUSTMENT WHEN WATER IS TOO COLD

PRY RED RING

FORWARD AND ROTATE CLOCKWISE

4HANDLE INSTALLATION

Install HANDLE (1) by pushing it onto CARTRIDGE STEM (2) and tightening SET SCREW (3) from below with 2.5mm Hex Wrench supplied.

2

1

3

2.5MM HEX WRENCH

5SERVICE

If faucet drips, operate handle several times from "off" to "on". Do not apply excessive force.

Clogged CARTRIDGE (4) inlets may cause reduced flow in "full on" hot or cold. To clean inlets, first turn off water supply, then:

Remove HANDLE (1), CAP (2) and CARTRIDGE (4). Clean inlets and MANIFOLD (5).

Reassemble CARTRIDGE (4), alternately tightening SCREWS (3). Replace CAP (2) and HANDLE (1). Check flow.

1

4	2
	3

5

6CARE INSTRUCTIONS:

DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.

DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE.

M968592 Rev.1.1