American Standard 2748.018WC.K2, 2748.002 General Specifications for 2748 Bathing Pool

TOWN SQUARE® 5' x 42"

WHIRLPOOL AND BATHING POOL

HIGH GLOSS

		59-1/2"
ON/OFF		(1511mm)
		INTEGRAL	3"
SWITCH
	29-7/8"	FITTING DECK	(76mm)
		2-1/2" X 14"	5-1/4"
	(759mm)
		(64 X 356mm)	(133mm)
14-1/2"
(368mm)			C/L OF
			DRAIN
41-5/8"			OUTLET
			EDGE OF
(1057mm)
PROVIDE ACCESS	FLOOR CUTOUT		FLOOR
	5" X 12"		CUTOUT
TO PUMP FOR	(127 X 305mm)
SERVICE ON ALL
INSTALLATIONS
PUMP
			3/4"
			(19mm)

	OUTLINE OF	JETS (6)		SUCTION	OUTLINE OF CUTOUT
SKID RESISTANT					58-1/4" X 40-1/4"
	SURFACE				(1480 X 1022mm)
		PUMP		LEVELING STRINGER
				(NOT FOR SUPPORT)
	2"	C/L OF	SAFE-T-HEATER
(51mm)		OVERFLOW	REMOVABLE
			BLANK
	5-3/4"					23"
(146mm)						(584mm)
					ROUGH	21"
						(533mm)
					FLOOR
		1-1/2" N.P.T.			INTEGRAL
					FEET
		THREADS
					SUPPORT
3-1/8"	3/4"	1-1/2" O.D.
(79mm)	(19mm)	TAILPIECE

		59-1/2"
		(1511mm)	3"
		INTEGRAL
	29-7/8"	FITTING DECK	(76mm)
		2-1/2" X 14"	5-1/4"
	(759mm)
		(64 X 356mm)	(133mm)
14-1/2"
(368mm)			C/L OF
			DRAIN
			OUTLET
			EDGE OF
	FLOOR CUTOUT		FLOOR
41-5/8"	5" X 12"		CUTOUT
	(127 X 305mm)
(1057mm)
			3/4"
			(19mm)
OUTLINE OF		OUTLINE OF CUTOUT
SKID RESISTANT		58-1/4" X 40-1/4"
SURFACE		(1480 X 1022mm)

		C/L OF	LEVELING STRINGER	2"
		OVERFLOW	(NOT FOR SUPPORT)	(51mm)
5-3/4"				23"
				(584mm)
(146mm)
				21"
			ROUGH
				(533mm)
			FLOOR
		1-1/2" N.P.T.	INTEGRAL
			FEET
		THREADS
			SUPPORT
3-1/8"	3/4"	1-1/2" O.D.
(79mm)	(19mm)	TAILPIECE

GENERAL SPECIFICATIONS FOR 2748 WHIRLPOOL

INSTALLED SIZE		59-1/2 x 41-5/8 x 23 In. (1511 x 1057 x 584mm)
WEIGHT				110 Lbs. (50 Kg.)
WEIGHT w/WATER				611 Lbs. (278 Kg.)
GAL. TO OVERFLOW				60 Gal. (227 L)
WHIRLPOOL MIN. OPERATING VOL.				55 Gal. (208 L)
BATHING WELL AT SUMP				34 x 24 In. (864 x 610mm)
BATHING WELL AT RIM			52 x 31 In. (1321 x 1321mm)
WATER DEPTH TO OVERFLOW				12-1/2 In. (318mm)
FLOOR LOADING			40 Lbs./Sq.Ft. (194 Kgs./Sq.m)
(PROJECTED AREA)
PTS.					27.8
CUBE (FT3)						45.4
	WHIRLPOOL ELECTRICAL SPECIFICATIONS
WHIRLPOOL PUMP				1.6 HP, 9.7 AMPS ,120V.

GENERAL SPECIFICATIONS FOR 2748 BATHING POOL

INSTALLED SIZE				59-1/2 x 41-5/8 x 23 In.
				(1511 x 1057 x 584mm)
WEIGHT						110 Lbs. (50 Kg.)
WEIGHT w/WATER					611 Lbs. (278 Kg.)
BATHING WELL AT SUMP			34 x 24 In. (864 x 610mm)
BATHING WELL AT RIM		52 x 31 In. (1321 x 1321mm)
WATER DEPTH TO OVERFLOW					12-1/2 In. (318mm)
FLOOR LOADING	40 Lbs./Sq.Ft. (194 Kgs./Sq.m)
(PROJECTED AREA)
PTS.							27.8
CUBE (FT3)								45.4

NOTES:

BATH CAN BE INSTALLED EITHER ABOVE OR BELOW FLOOR LINE AS PIER, ISLAND OR PENINSULA TYPE INSTALLATION. SUMP OF BATH IS SUPPORTED BY INTEGRAL FEET. NO ADDITIONAL SUPPORT REQUIRED. ENCLOSING MATERIALS BY OTHERS.

●IF INSTALLING A DECK-MOUNTED FITTING, BEFORE DRILLING ANY HOLES: CHECK FOR INTERFERENCE WITH CIRCULATING SYSTEM PIPING AND DRAIN OVERFLOW. MOUNTING HOLES DRILLED BY INSTALLER.

OPTIONAL TILING BEAD KIT No. 751755-200 AVAILABLE.

■REFER TO INSTALLATION INSTRUCTIONS SUPPLIED WITH WHIRLPOOL FOR ADDITIONAL INFORMATION. FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.

PROVIDE SUITABLE REINFORCEMENT FOR ALL SUPPORTS.

IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances established by ANSI Standard Z124.1 / CSA Certified. These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided leaflet.

	H26
© 2008 AS America Inc.		Rev. 2/08