3 INSTALL HAND SHOWER
Unscrew the HOLDER (1) from the SHOWER ESCUTCHEON (2). Slip the SHOWER HOSE (3) through the SHOWER ESCUTCHEON (2) and the HOLDER (1).
Pull out the SLEEVE GUARD (6) and HOSE (7). Unthread the SLEEVE GUARD (6) from the HOSE END (8) connection. Be careful not to allow the HOSE (7) to fall back through the SLEEVE (9).
Insert SEAL WASHER (10) into the SHOWER HOSE CONNECTOR (11). Thread the SHOWER HOSE CONNECTOR (11) onto the HOSE END (8) and tighten securely.
5
1
13
4
Thread the SHOWER ESCUTCHEON (2) into the SLEEVE (9) until the SHOWER ESCUTCHEON (2) contacts the finished deck.
2
Loosen the SET SCREW (12) in the SHOWER ESCUTCHEON (2) and rotate the ESCUTCHEON (2) so that SET SCREW (12) faces the center of the tub. Retighten the SET SCREW (12).
Thread the HOLDER (1) into the SHOWER ESCUTCHEON (2).
Insert a SEAL WASHER (4) into the SHOWER HOSE CONNECTOR (5)
and hand tighten HAND SHOWER (13) into SHOWER HOSE CONNECTOR (5). Place the HAND SHOWER (13) into the HOLDER (1).
11
6 | 10 |
|
8
7
9
3
13
1
12
2
4 TEST INSTALLED DIVERTER
Turn DIVERTER VALVE (1) fully clockwise (Tub fill position). |
| 2 |
Turn on control valves and check all connections for leaks. With |
|
|
DIVERTER VALVE (1) in clockwise position, flow should only come |
|
|
from tub spout. |
|
|
Lift HANDSHOWER (2) from holder, direct spray into tub, turn |
| 3 |
DIVERTER VALVE (1) fully | 1 | |
HANDSHOWER (2) and HOSES (3) for leaks. With DIVERTER |
| |
|
|
VALVE (1) in
Turn control valves "off."
5 EverClean™ Finish Care Instructions
American Standard’s EverClean finish will wipe clean with a soft, dry cloth. A soft cloth with clean water may also be used, if desired. No additional cleaning products are required.
DO NOT USE: Soaps, acid, polish, abrasives, harsh cleaners, or a cloth with a coarse surface.
M 9 6 8 8 4 2 R E V 1 . 1