Lenoxx Electronics CD-107 Choosing the Power Sources, Connecting the AC power cord, AC Socket

CHOOSING THE POWER SOURCES

You can use the AC power or batteries as a power source.

AC SOCKET To a wall outlet

NOTE: One blade of plug and outlet is wider.

Battery compartment

TIP

• If the plug of the AC

power cord does not

match your outlet, do not

force it.

Reverse it and try again.

The plugs are polarized

and only fits one way into

the wall outlet and back

of the set.

• Replace the batteries

when the POWER lamp

dims or when the player

stops operating. Replace

all the batteries with new

ones. Before you replace

the batteries, be sure to

take out the CD from the

player and remember to

1. Connecting the AC power cord

Insert one end of the supplied AC power cord (located in the battery compartment) into the socket located at the rear of the player, and the other end to the wall outlet.

2. Using the player on batteries

Insert 6 size “C” batteries (not supplied) into the battery compartment.

To use the player on batteries, disconnect and remove the AC power cord from the player.

upper	$	#	Insert new batteries
upper	"	!	according to sequence
			as shown on FIG. 1.
lower		￿

check the Battery Safety

Instructions on Page 3.

FIG. 1

+	+
+	+

FIG. 2

To remove the batteries, (open the door) stick your finger into the hole on the bottom of the set and push the batteries out as shown on FIG. 2.

4IB-CD107(AD)-FD-E-V1