Configuration

As previously mentioned under GENERAL INFORMATION, KABERs are supplied configured for use in TRI-WIRED mode. (see below)

To convert KABERs to BI-WIRED mode remove the black-ringed (negative) input terminal collars using the key provided. Fit the two way plate supplied over the bottom two sockets and replace the terminal collars. Repeat this operation with the red (positive) terminals. (see below)

To convert KABERs to SINGLE WIRED mode follow the instructions above, but fit the three way plate supplied. (see below)

IMPORTANT Do not remove all the collars at once.

It is advisable to get your dealer to make up the necessary leads for you.