Dometic 2500 manual To Close on Straight Sided Vehicle

A&E CATALINA 2500

C. Tighten lock knob on arm assembly.

5.Using wand, hook pull-strap and pull awning out by unrolling the fabric (FIGS. 5A and 5B).

FULL EXTENSION

During operation for fully extended awning, fabric can be rolled out and rafter lock buttons will automatically snap into place to lock awning in full extension. Listen for “Click” of rafter lock buttons and continue to pull on pull-strap to make sure that rafter locks are fully set before releasing pull-strap. Tighten lock knobs (FIG. 5C).

PARTIAL EXTENSION

For partially extended awning operation, roll fabric out to desired extension and while firmly grasping pull-strap tighten rafter lock knobs (FIG. 5D).

Note: Make sure that rafter lock knobs are tightened before releasing pull-strap.

FOR PATIO POSITION

6.Place arm assembly in a vertical position and adjust height (FIG. 6).

7.Drive in the supplied spikes through awning foot to secure arm to ground (FIG. 7). Repeat for other side.

The Catalina 2500 Awning is now ready for you to enjoy.

8.Rain Release Setting: To avoid damage to the awning due to rain water collecting on the canopy, simply lower one of the arms enough to let the water drain from that side (FIG. 8).

TO CLOSE

Note: To close on curved sided vehicles skip to Step 6.

TO CLOSE ON STRAIGHT SIDED VEHICLE

1.IF AWNING IS SET IN PATIO POSITION:

A.Remove spikes from awning foot.

B.Attach foot to bottom mounting bracket on side of vehicle to set awning into pivot position (FIG. 1).

2.IF AWNING IS SET IN PIVOT POSITION:

Lower each arm assembly to closing position indicated by arrow on inner arm and tighten lock knob (FIG. 2).

6