Exmark M217B manual Maintenance, Servicing Air Cleaner, Replacing Spark Plug, Cutting Leaves

Page 15

Cutting Leaves

When cutting is complete, always be sure that 50% of the lawn shows through the cut leaf cover. This may require one or more passes over the leaves.

For light leaf coverage, position all wheels at the same height-of-cut setting.

If there are more than five inches of leaves on lawn, set the front wheels one or two notches higher than the rear wheels. This makes it easier to feed leaves under mower deck.

Walk at a slower mowing speed if leaves are not being cut up finely enough to be hidden down in the grass.

If you cut up a lot of oak leaves, you might want to add lime to your grass in the spring. Lime reduces the acidity of oak leaves.

Maintenance

POTENTIAL HAZARD

If you leave the wire on the spark plug, someone could start the engine.

WHAT CAN HAPPEN

Accidental starting of engine could seriously injure you or other bystanders.

HOW TO AVOID THE HAZARD

Pull wire off spark plug before you do any maintenance. Also push wire aside so it does not accidentally contact spark plug.

Servicing Air Cleaner

Normally, clean air cleaner pre±cleaner after every 25 operating hours or every season. Clean the paper cartridge after every 100 hours or every season. More

frequent cleaning is required when mower is operated in dusty or dirty conditions. Replace air cleaner parts, if very dirty.

IMPORTANT: Do not operate engine without air filter elements; extreme engine wear or damage will occur.

Note: Tipping mower on wrong side to service underside of mower may cause damage to air filters.

1.Stop engine and pull wire off spark plug (Fig. 10).

2.Remove two (2) knobs securing air cleaner cover to engine (Fig. 16).

3.Lift cover off. Clean cover thoroughly.

4.Carefully remove pre±cleaner. If pre±cleaner is dirty, carefully wash it in a solution of liquid soap and warm water. Rinse in clear water. Allow to dry thoroughly before using.

5.If paper cartridge is dirty, clean the paper filter by tapping it gently on a flat surface. If very dirty, replace cartridge.

IMPORTANT: Do not oil pre±cleaner or paper cartridge. Do not use pressurized air to clean paper cartridge.

6.Reinstall pre±cleaner over paper cartridge. Reinstall air cleaner cover and tighten securely in place with two (2) knobs.

Replacing Spark Plug

Remove plug after every 25 operating hours and check its condition. Replace spark plug every 100 operating hours or every season. Use a Champion RC12YC spark plug or equivalent.

1.Stop engine and wait for all moving parts to stop. Pull wire off spark plug (Fig. 10).

2.Clean around spark plug and remove plug from cylinder head.

11

Image 15
Contents Operators Manual MetroHealth Warning Gasoline Exmark Parts PLUS Program Paste Label from Contents SpecificationsSafety General Operation Safe Operating PracticesWhile Operating Maintenance And Storage Safety and Instruction Decals Before Starting AssemblyOperation GasolineOperating Tips Using Discharge Tunnel Plug Using Grass BagStarting and Stopping Adjusting Height-of-Cut Mulching Tips General TipsCutting Grass Cutting Leaves MaintenanceServicing Air Cleaner Replacing Spark PlugDraining Gasoline Adjusting ThrottleCleaning Cooling System Adjusting Wheel DriveInspecting, Removing Sharpening Blade Servicing Wheels Adjusting Blade Brake CableLubrication Lubricating Gear CaseDischarge Tunnel Cleaning MowerUnderside of Mower Housing PlugReplacing the Fuel Filter StorageFuel Filter Belt Cover self-propelled model onlyAccessories Warranty Page Briggs & Stratton Emission Control Defects Warranty Coverage Improper maintenance Briggs & Stratton Engine Owner Warranty Policy Figures Figures Control bar Fingertip starter Throttle English 020 0,5 mm Blade Lockwasher Bolt Accelerator #/16º-!/4º Right rear wheel Date Description Work Done Service Done ByFAX 402223±6384 402 223±6300