MOWER MAINTENANCE
Cutterblade Sharpening
A slightly worn cutterblade may be
Sharpen both cutting edges with a flat file to restore per- formance. (Refer fig.30)
Ensure that the cutterblade is balanced. Use a screw driv- er with a round shaft to support the cutterblade through its centre hole. Hold the cutterblade horizontal and then release. A balanced cutterblade will remain horizontal.
(Refer fig.31)
If the cutterblade is not balanced the heavy end will rotate downwards. Sharpen the heavy end until the cutterblade is correctly balanced. (Refer fig.32)
Storage
To store the handlebar unscrew the 2 small securing knobs sufficiently to allow it to be pivoted forwards to rest against the mower. Take care to ensure that the con- trol cables do not become snagged at the pivot point and depress the engine stop lever to prevent it being damaged through contact with the engine. (Refer fig.33)
Engines stored in excess of 30 days need to be protected with Briggs & Stratton fuel additive or drained of fuel to prevent gum from forming in the fuel system or on essen- tial carburettor parts. To ensure your mower is maintained in good working order it is important that the following procedure is adopted. Refer to the Maintenance section as necessary.
-Drain fuel from the engine by operating the engine until it stops.
-Disconnect the spark plug lead.
-Change the engine oil.
-Remove the engine spark plug and pour 15ml of engine oil into the engine cylinder and replace the spark plug. Do not exceed the stated volume of oil as engine damage may occur on
-Clean grass and debris from the engine cylinder, cylinder head cooling fins, under top cowl, around and behind ex- haust/exhaust guard and ensure that the grassbag is clean.
-Lubricate the mower and treat metal parts with a water repellent
-Cover the mower with a protective sheet and store it in a dry, ventilated area.
Fig. 30 | Fig. 31 | Fig. 32 | Fig. 33 |
|
|
|
13