Hunter Fan 42426-01 Setting the Remote Transmitter and Receiver, Setting DIP switches

Page 9

4 • Setting the Remote Transmitter and Receiver

Setting DIP switches

When two or more fans are located near each other, you may desire to have the receiver/transmitter for each fan set to a different code, so that the operation of one fan does not affect the operation of the other fans.

The DIP switches for the receiver are located on the flat surface of the receiver. The DIP switches for the transmitter are in the the battery compartment.

4-1. IMPORTANT! Before you change the DIP switch settings, make sure the battery is not connected to the transmitter.

Change the position of the DIP switches in the remote transmitter and the receiver. Make sure that the DIP switches match in

the remote receiver and transmitter. If they don’t match, the transmitter will not function.

4-2. There is a toggle switch beside the DIP switches on the transmitter. Move the toggle switch toward the side that reads “CFL” if you are going to operate the fan with CFL bulbs. Move the switch to the “INC” side if you are going to use incandescent bulbs.

4-3. Install the included 9-volt battery into the transmitter.

CAUTION: The remote control device complies with part 15 of the FCC rules. Changes or modifications not expressly approved by Hunter Fan Company could void your authority to operate this equipment.

Operation is subject to the following two conditions:

1.This device may not cause harmful interference.

2.This device must accept any interference received, including interference that may cause undesired operation.

WARNING: Use only the Hunter Fan speed control supplied with this fan.

4-4. Raise the fan and align the slots in the canopy with the hooks on the ceiling plate.

Note: To hang the fan, you must tilt the canopy to an almost vertical position so that the canopy slots sit on the ceiling plate hooks.

Receiver DIP

switches

Transmitter DIP switches

Example DIP Switch Settings

Receiver 1

Receiver 2

DIP Switches

DIP Switches

Set to 0111

Set to 0100

Transmitter 1

Transmitter 2

DIP Switches

DIP Switches

Set to 0111

Set to 0100

9

42426-01 • 03/29/10 • Hunter Fan Company

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Type 2 Models Welcome Checklist for Existing Fan Site Choose the Fan SiteChoose a fan site where Install the Outlet Box Install a Support Brace, If NecessaryPrepare the Wiring Cut the Ceiling HoleConsidering Optional Accessories Understanding Mounting and Installer’s ChoiceGetting Ready Installing Multiple Fans?Gathering the Tools Checking Your Fan PartsFlat Washer Wood Screw Toward Ceiling Peak Installing the Ceiling PlateFor Standard or Angled mounting Assembling and Hanging the FanFor Low Profile mounting Hanging the FanSetting DIP switches Setting the Remote Transmitter and ReceiverMake sure the power is still off Wiring the FanInstalling the Canopy and Canopy Trim Ring Assembling the Blades Steps 8-1 Steps 8-7 Operating the Remote Control and Mounting the Holder To Change Airflow Direction Operating and Cleaning Your Ceiling FanProblem Nothing happens fan does not move TroubleshootingProblem Noisy operation Problem Excessive wobbling
Top Page Image Contents