Hunter Fan 41936-01 warranty Assembling and Hanging the Fan

4 • Assembling and Hanging the Fan

You can assemble your fan for standard mounting (steps 4-1 – 4-3) or for low profile mounting (steps 4-4 – 4-6).

4-1. If your ceiling is 9’ or higher, remove the 3” downrod pipe from the black ball. Remove the screw and push the pipe up through the ball. Remove the cross bar. read the cross bar through the longer (6”) pipe and insert the pipe into the black ball. Tighten the screw completely.

4-2. Insert the downrod through the canopy and canopy trim ring. Feed the wires from the fan through the downrod on one side of the pin in the ball.

4-3. Loosen the square head set screw on the adapter to install the pipe and ball assembly. Note: When the pipe and ball assembly is fully installed, 2-3 threads on the pipe will still be visible; this is normal. Securely retighten the set screw with a wrench or pliers. Skip to Step 4-7.

CAUTION: e adapter has a special coating on the threads. Do not remove this coating; the coating prevents the downrod from unscrewing. Once assembled, do not remove the downrod.

4-4. Remove the set screw from the adapter.

Note: For low profile mounting, the downrod is replaced with the low profile washer. See Steps 4-4 – 4-6.

4-5. Place the low profile washer (lip up) into the canopy. Be sure the green ground wire is pointing up toward the ceiling.

4-6. Align the holes in the washer with the holes in the adapter. Assemble securely with three locking screws.

4-7. Raise the fan and place the hook on the ceiling plate through the U-shaped hole in the rim.

WARNING: Fan may fall if not assembled as directed in these installation instructions.

Step 4-7

U-shaped

Hole

Locking

Screw

Step 4-1 Pipe Ball Screw

Ground Wire

and Screw

Pin

Ball

Wedge

Steps 4-2 – 4-3

Downrod

Canopy

Canopy

Trim Ring

Set Screw

Steps 4-5 – 4-6 Low Profile Washer

7

41936-01 • 11/18/05 Hunter Fan Company