OPERATION
GASOLINE FILLER CAP
MUFFLER
CHOKE
CON-
TROL
PRIMER
SAFETY IGNITION KEY
ELECTRIC AUGER
START CONTROL
BUTTON LEVER
RECOIL (AUXILIARY)
STARTER
HANDLE
CHUTE DEFLECTOR
DISCHARGE CHUTE CONTROL LEVER
DEFLECTOR REMOTE
DRIVE SPEEDCONTROL LEVER CONTROL LEVER
TRACTION
DRIVE
CONTROL
LEVER
LH TURN
TRIGGER
LIGHT
FUEL
THROTTLE / ENGINE CONTROL
DISCHARGE
CHUTE
HANDLE KNOB
MUFFLER
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE ENGINE. ACTUAL LOCATION MAY VARY WITH THE ENGINE ON YOUR UNIT.
AUGERS
FIG. 10
TOOLBOX
SKID PLATE
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to store spare shear bolts, locknuts and wrench.
Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use.
Electric start button - used for starting the engine.
Recoil (auxiliary) starter handle - used for starting engine.
Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine.
Throttle/engine control - used to select either FAST or SLOW engine speed and to STOP the engine.
Drive speed control lever - used to select forward or reverse motion and speed of snow thrower.
Choke control - used for starting a cold engine.
Traction drive control lever - used to engage
LH and RH turn triggers - used to steer the snow thrower.
Deflector remote control lever - used to change the distance the snow is thrown.
Auger control lever - used to engage auger motion (throw snow).
Discharge chute control lever - used to change the di- rection the snow is thrown.
Skid plate - used to adjust height of scraper bar from the
9ground.