ASSEMBLY
TO ASSEMBLE GRASS CATCHER (See Figs. 3 and 4)
1.Slide grass catcher bag over the frame. Make sure the rear handle is on top (the same side as the front handle) and the strap is on the bottom.
2.Slip vinyl bindings over frame.
NOTE: If vinyl bindings are too stiff, hold them in warm water for a few minutes. If bag gets wet, let it dry before using.
3. Close grass catcher door.
NOTE: When fully closed, door will “snap” shut over frame and vinyl bindings.
TO INSTALL ATTACHMENTS
Your lawn mower was shipped ready to be used as a mulcher. To convert mower to bagging or discharging, see “TO CONVERT MOWER” in the Operation section of this manual.
TO PREPARE BATTERY (See Fig. 5)
NOTE: Your battery must be charged before you can start your lawn mower.
1.Connect battery charger connector (male) to harness connector (female).
2.Plug battery charger into 110 volt A.C. outlet.
3.Leave battery charger connected for 24 hours before starting your engine for the fi rst time.
4.After charging, disconnect harness connector (female) from battery charger connector (male).
Connect your battery charger to charge battery after each use.
IMPORTANT: The engine will not recharge your battery.
STRAP
REAR HANDLE
At the end of the mowing season the battery should be charged for 48 hours to protect the battery during winter storage.
FRONT
HANDLE
DOOR
FIG. 3
DOOR
GRASS
CATCHER
FRAME
VINYL
BINDINGS
BAG
FIG. 4
CAUTION: Always disconnect the engine connector (male) from the battery connector (female) to prevent accidental starting when transporting or storing your lawn mower after the season.
BATTERY CHARGER | BATTERY |
| BOX |
CHARGER |
|
CONNECTOR |
|
(MALE) |
|
HARNESS |
|
CONNECTOR |
|
(FEMALE) |
|
ENGINE CONNECTOR (MALE) |
|
FIG. 5
5