Husqvarna 917.37594 owner manual Storage, To Adjust Handle See Fig, Carburetor

Page 15

SERVICE AND ADJUSTMENTS

2.Route the other end of the new drive belt through hole in housing.

3.Reattach debris shield to housing with screw previ- ously removed. Be sure tab of debris shield is in gap of housing.

4.Position blade on the blade adapter aligning the two

(2)holes in the blade with the raised lugs on the adapter.

5.Be sure the trailing edge of blade (opposite sharp edge) is up toward the engine as shown (See Fig. 19).

6.Install the blade bolt with the lock washer and hardened washer into blade adapter and crankshaft.

7.Use block of wood between blade and lawn mower housing and tighten the blade bolt, turning clockwise.

•The recommended tightening torque is 35-40 ft. lbs.

IMPORTANT: BLADE BOLT IS HEATTREATED. IF BOLT NEEDS REPLACING, REPLACE ONLYWITH APPROVED BOLT SHOWN IN THE REPAIR PARTS SECTION OF THIS MANUAL.

8.Return mower to upright position.

9.Install new drive belt into idler arm assembly, then around the drive pulley. Be sure belt is inside of belt keepers (See Fig. 18).

NOTE: Pulling on the drive belt (to install it on the drive pulley) will cause the other end of the belt to free itself from the debris shield retainer and come into contact with the pulley end of the blade adapter.

10.Reattach drive cable and return spring to the idler arm assembly, then reattach drive cable to anchor.

11.Reattach drive cover with screws previously removed (See Fig. 17).

12.Connect spark plug wire to spark plug.

TO ADJUST HANDLE (See Fig. 21)

The handle on your lawn mower has multiple height posi- tions - adjust to height that suits you.

1.Remove knob and carriage bolt on one side of the lower handle.

2.While holding handle assembly, remove knob and car- riage bolt from opposite side, align hole in handle with desired hole in handle bracket and reassemble bolt and knob and tighten securely.

3.Align opposite side of handle with same positioning hole and secure with bolt and knob.

KNOB

BOLT

LOW

HIGH

HANDLE

BRACKET

 

FIG. 21

ENGINE

ENGINE SPEED

Your engine speed has been factory set. Do not attempt to increase engine speed or it may result in personal injury. If you believe that the engine is running too fast or too slow, take your lawn mower to an authorized service center for repair and adjustment.

CARBURETOR

Your carburetor is not adjustable. If your engine does not operate properly due to suspected carburetor problems, take your lawn mower to an authorized service center for repair and/or adjustment.

IMPORTANT:NEVERTAMPERWITHTHEENGINEGOVERNOR, WHICH IS FACTORY SET FOR PROPER ENGINE SPEED. OVERSPEEDING THE ENGINE ABOVE THE FACTORY HIGH SPEED SETTING CAN BE DANGEROUS. IF YOU THINK THE ENGINE-GOVERNED HIGH SPEED NEEDS ADJUSTING, CONTACTYOUR NEAREST AUTHORIZED SERVICE CENTER, WHICH HAS PROPER EQUIPMENT AND EXPERIENCE TO MAKE ANY NECESSARY ADJUSTMENTS.

STORAGE

Immediately prepare your lawn mower for storage at the end of the season or if the unit will not be used for 30 days or more.

LAWN MOWER

When lawn mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

1.Clean entire lawn mower (See “CLEANING” in the Maintenance section of this manual).

2.Lubricate as shown in the Maintenance section of this manual.

3. Be sure that all nuts, bolts, screws, and pins are se- curely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

4.Touch up all rusted or chipped paint surfaces; sand lightly before painting.

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents 917.375940 III. Children Safe Operation Practices for Walk-Behind MowersII. Slope Operation General OperationTable of Contents To Unfold Handle See Figs AssemblyHOW to SET UP Your Lawn Mower To Remove Lawn Mower from CartonTo Assemble Grass Catcher See Figs To Install AttachmentsMeets Cpsc Safety Requirements OperationKnow Your Lawn Mower HOW to USE Your Lawn Mower Engine SpeedEngine Zone Control For Side Discharging Side DischargingFor Mulching For Rear BaggingADD OIL See Fig Before Starting EngineTOEMPTYGRASSCATCHERSeeFigs.10-11 ADD Gasoline See FigMulching Mowing Tips To Stop EngineTo Start Engine Mowing TipsBefore Each USE MaintenanceLubrication Chart General RecommendationsEngine Lawn MowerSpark Plug CleaningClean Under Drive Cover MufflerTo Remove Drive Belt See Figs Service and AdjustmentsTo Adjust Cutting Height Rear DeflectorTo Adjust Handle See Fig StorageCarburetor Engine OIL OtherHandle See Figs Fuel SystemProblem Cause Correction Troubleshooting PointsRotary Lawn Mower - Model Number KEY Part Description Rotary Lawn Mower - Model Number Rotary Lawn Mower - Model Number KEY Part Description Service Notes Rantywar Tementsta

917.37594 specifications

The Husqvarna 917.37594 is a versatile and powerful lawn tractor that stands out in the realm of outdoor power equipment. Recognized for its exceptional cutting performance and user-friendly design, this model is well-suited for homeowners with medium to large lawns.

One of the key features of the Husqvarna 917.37594 is its robust 24 HP Briggs & Stratton engine, which provides ample power to tackle various mowing conditions. This engine ensures reliable performance throughout the mowing season, whether you're cutting through thick grass or navigating uneven terrain. The automatic transmission allows for smooth and effortless acceleration, enhancing the overall user experience.

Another highlight of the 917.37594 is its 54-inch cutting deck. This wide cutting deck allows users to cover more ground in less time, making mowing efficient and effective. The cutting deck also has an adjustable height feature, offering six different positions so that users can achieve their desired grass length. This flexibility is ideal for maintaining a healthy lawn throughout various seasons.

The Husqvarna 917.37594 is equipped with the exclusive ClearCut™ deck technology, which optimizes airflow for a superior cut. This technology ensures that grass is evenly distributed for a clean finish and reduces clumping, resulting in a professional-looking lawn.

Furthermore, this model integrates an innovative washing port that simplifies deck maintenance. By connecting a garden hose to the washing port, users can clean the underside of the deck without the hassles of manual scrubbing. This feature significantly reduces maintenance time, allowing more hours for enjoying your yard.

Comfort is another top priority with the Husqvarna 917.37594. The ergonomically designed seat is adjustable, providing optimal comfort for users of all sizes. Coupled with easy-to-reach controls, it helps to create a user-centric environment for extended mowing sessions. Safety features, such as the automatic blade brake and robust frame, add an extra layer of security during operation.

In summary, the Husqvarna 917.37594 is designed for efficiency, comfort, and reliability. With its powerful engine, spacious cutting deck, advanced technologies, and user-friendly features, this lawn tractor is an excellent choice for homeowners looking to maintain a picturesque lawn with ease. Whether you're a seasoned landscaper or a casual homeowner, the 917.37594 proves to be a prudent investment for years of dependable service.
Top Page Image Contents