Husqvarna 917.2896 Install Seat See Figs, To Adjust Seat See Fig, To Install Hood Scoop See Fig

Page 7

ASSEMBLY

INSTALL SEAT (See Figs. 3 and 4)

•Remove bolt and flat washer securing seat to cardboard packing and set aside for assembly of seat to tractor. Remove the cardboard packing and discard.

•Connect switch to seat.

•Place seat on seat pan so all three (3) bottom pads are positioned over large slotted holes in pan.

SEAT

SWITCH

PAD

SLOT

SEAT

PAN

TAPE

WIRING HARNESS

Fig. 3

•Push down on seat to engage pads in slots and pull seat towards rear of tractor.

•Raise seat and tighten bolt securely.

•Remove tape and discard.

•Lower seat into operating position and sit on seat. Press clutch/brake pedal all the way down. If operating position is not comfortable, adjust seat.

TO ADJUST SEAT (See Fig. 4)

•Grasp adjustment handle and pull up, slide seat to desired position and release adjustment handle.

	SLOT		TAPE
	PAD
	FLAT
	WASHER
	SEAT PAN
	BOLT	TAB	ADJUSTMENT
	BOLT	TAB	HANDLE
			HANDLE

Fig. 4

TO INSTALL HOOD SCOOP (See Fig. 5)

Fig. 5

7

Image 7

Contents 917.289600 II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing III. ChildrenSafe Handling of Gasoline Table of Contents Steering Wheel Unassembled PartsBefore Removing Tractor from Skid AssemblyTools Required for Assembly ToremovetractorfromcartonTo Adjust Seat See Fig Install Seat See FigsTo Install Hood Scoop See Fig Check Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor To USE Throttle Control D See Fig HOW to USE Your TractorTo SET Parking Brake See Fig Stopping See FigTo Stop Mower Blades To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To Operate MowerBefore Starting the Engine Purge Transmission Mowing TipsSchedule MaintenanceMaintenance General RecommendationsBlade Removal See Fig BatteryTractor Blade CareEngine Spark Plugs CleaningEngine Cooling System See Fig MufflerTo Install Mower See Service and AdjustmentsTo Remove Mower See Fig Install belt on engine pulley M, in belt keepers G To Level Mower To Check Brake To Replace Mower Blade Drive Belt See FigTo Replace Motion Drive Belt See Fig To Remove Wheel See Fig Transaxle Motion Control Lever Neutral Adjustment See FigTo Adjust Steering Wheel Alignment To Start Engine with a Weak Battery See FigTransmission Engine OIL StorageOther Fuel SystemProblem Cause Correction TroubleshootingEngine continues Wheels and Tires DecalsOptional Twin CYL. Engines SchematicElectrical Tractor - Model Number LTH18538 Chassis Tractor - Model Number LTH18538 Drive Tractor - Model Number LTH18538 Engine Engine Power Rating Information Steering Assembly Tractor - Model Number LTH18538 Mower Deck Tractor - Model Number LTH18538 100 101 Mower LiftSeat-tex6-tex LT Seat AssemblyTufftorq Transaxle Model NO. K46BA Model K46BATufftorq Transaxle Model NO. K46BA Briggs Engine Model Number 31N707, Type Number 1374-B1 KEY Part Description Briggs Engine Model Number 31N707, Type Number 1374-B1 Service Notes Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe Operation05.04.10 JA