Husqvarna 6522SL Assembly, HOW to SET UP Your Lawn Mower, To Remove Lawn Mower from Carton

Page 4

ASSEMBLY

Read these instructions and this manual in its entirety before you attempt to assemble or operate your new lawn mower.

IMPORTANT: THIS LAWN MOWER IS SHIPPED WITH- OUT OIL OR GASOLINE IN THE ENGINE.

Your new lawn mower has been assembled at the factory with the exception of those parts left unassembled for ship- ping purposes. All parts such as nuts, washers, bolts, etc., necessary to complete the assembly have been placed in the parts bag. To ensure safe and proper operation of your lawn mower, all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to ensure proper tightness.

TO REMOVE LAWN MOWER FROM CARTON

1.Remove loose parts included with mower.

2.Cut down two end corners of carton and lay end panel down fl at.

3.Remove all packing materials except padding between upper and lower handle and padding holding operator presence control bar to upper handle.

4.Roll lawn mower out of carton and check carton thor- ougly for additional loose parts.

HOW TO SET UP YOUR LAWN MOWER

TO UNFOLD HANDLE (See Fig. 1)

IMPORTANT: UNFOLD HANDLE CAREFULLY SO AS NOT TO PINCH OR DAMAGE CONTROL CABLES.

1.Raise handles until lower handle section locks into place in mowing position.

2.Remove protective padding, raise upper handle sec- tion into place on lower handle and tighten both handle knobs.

3.Remove handle padding holding operator presence control bar to upper handle.

Your handles may be adjusted for your mowing comfort. Refer to “ADJUST HANDLE” in the Service andAdjustments section of this manual.

OPERATOR

MOWING

PRESENCE

POSITION

CONTROL

 

BAR

 

 

LIFT

 

UP

LIFT

UPPER

UP

HANDLE

HANDLE

KNOB

LOWER

HANDLE

FIG. 1

TO ASSEMBLE GRASS CATCHER (See Fig. 2)

1.Put grass catcher frame into grass bag with rigid part of bag on the bottom. Make sure the frame handle is outside of the bag top.

2.Slip vinyl bindings over frame.

NOTE: If vinyl bindings are too stiff, hold them in warm water for a few minutes. If bag gets wet, let it dry before using.

FRAME

HANDLE

VINYL

FRAME

BINDINGS

OPENING

FIG. 2

TO INSTALL ATTACHMENTS

Your lawn mower was shipped ready to be used as a mulcher. To convert mower to bagging or discharging, see “TO CONVERT MOWER” in the Operation section of this manual.

4

Image 4
Contents 6522SL Safe Operation Practices for Walk-Behind Mowers II. Slope OperationGeneral Operation III. ChildrenTable of Contents Assembly HOW to SET UP Your Lawn MowerTo Install Attachments To Remove Lawn Mower from CartonOperation Meets Cpsc Safety RequirementsKnow Your Lawn Mower HOW to USE Your Lawn Mower Engine SpeedEngine Zone Control To Convert MowerTo Empty Grass Catcher See Fig Before Starting EngineADD OIL See Fig ADD Gasoline See Fig To Stop EngineTo Start Engine Mowing TipsMaintenance Lubrication ChartGeneral Recommendations Before Each USELawn Mower Cleaning Clean Under Drive CoverEngine MufflerTo Adjust Cutting Height Service and AdjustmentsRear Deflector Carburetor StorageHandle See Figs Other Fuel SystemEngine OIL CylinderTroubleshooting Points Problem Cause CorrectionPage KEY Part Description Page 532 17 Rantywar Tementsta