ASSEMBLY
TO ASSEMBLE GRASS CATCHER (See Fig. 3)
1.Put grass catcher frame into grass bag with rigid part of bag on the bottom. Make sure the frame handle is outside of the bag top.
2.Slip vinyl bindings over frame.
NOTE: If vinyl bindings are too stiff, hold them in warm water for a few minutes. If bag gets wet, let it dry before using.
FRAME
HANDLE
VINYL | FRAME |
BINDINGS | OPENING |
FIG. 3
TO PREPARE BATTERY (See Fig. 4)
NOTE: Your battery must be charged before you can start your lawn mower.
1.Connect battery charger connector (male) to harness connector (female).
2.Plug battery charger into 110 volt A.C. outlet.
3.Leave battery charger connected for 24 hours before starting your engine for the first time.
4.After charging, disconnect harness connector (female) from battery charger connector (male).
Connect your battery charger to charge battery after each use.
IMPORTANT: THE ENGINE WILL NOT RECHARGE YOUR BATTERY. AT THE END OF THE MOWING SEASON THE BATTERY SHOULD BE CHARGED FOR 48 HOURS TO PROTECT THE BATTERY DURING WINTER STORAGE.
CAUTION: Always disconnect the engine connector (male) from the battery connector (female) to prevent accidental starting when transporting or storing your lawn mower after the season.
BATTERY CHARGER | BATTERY | ||
BOX | |||
|
| ||
HARNESS |
|
| |
CONNECTOR |
|
| |
(FEMALE) | CHARGER |
| |
| CONNECTOR |
| |
| (MALE) |
| |
ENGINE CONNECTOR (MALE) |
| ||
FIG. 4
TO INSTALL ATTACHMENTS
Your lawn mower was shipped ready to be used as a mulcher. To convert mower to bagging or discharging, see “TO CONVERT MOWER” in the Operation section of this manual.
5