Husqvarna 961 45 00-05 01, 532 41 44-89 owner manual Storage, To Adjust Handle, Carburetor

Page 16

TO ADJUST HANDLE

The handle on your lawn mower has three

(3)height positions - adjust to height that suits you.

• Squeeze the bottom ends of lower handle towards each other until the pin in handle can be inserted into one of the three height adjustment holes.

High

Handle pin

Medium

 

SQUEEZE

Low

Handle bracket

ENGINE

ENGINE SPEED

Your engine speed has been factory set. Do not attempt to increase engine speed or it may result in personal injury. If you believe that engine is running too fast or too slow, take your mower to a Husqvarna or other qualified service center for repair and adjustment.

CARBURETOR

Your carburetor is not adjustable. If your engine does not operate properly due to suspected carburetor problems, take your lawn mower to a Husqvarna or other qualified service center for repair and/or adjustment.

IMPORTANT: Never tamper with the engine governor, which is factory set for proper engine speed. Overspeeding the engine above the factory high speed setting can be dangerous. If you think the engine-governed high speed needs adjusting, contact a Husqvarna or other qualified service center, which has proper equipment and experience to make any necessary adjustments.

STORAGE

Immediately prepare your lawn mower for storage at the end of the season or if the unit will not be used for 30 days or more.

LAWN MOWER

When lawn mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

1.Clean entire lawn mower (See “CLEANING” in the Maintenance sec- tion of this manual).

2.Lubricate as shown in the Maintenance section of this manual.

3.Be sure that all nuts, bolts, screws, and pins are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

4.Touch up all rusted or chipped paint surfaces; sand lightly before painting.

HANDLE

You can fold your lawn mower handle for storage.

1.Loosen the two (2) handle knobs on sides of the upper handle and allow handle to fold down to the rear.

2.Squeeze the bottom ends of lower handle toward each other until pins in

handle clear the brackets and pivot entire handle assembly forward and allow it to rest on mower.

• When setting up your handle from the storage position, you must manually lock lower handle into mowing position.

IMPORTANT: When folding the handle for storage or transportation, be sure to fold the handle as shown or you may dam- age the control cables.

Operator

MOWING

presence

POSITION

control bar

 

FOLD

 

FORWARD

Upper

FOR

handle

STORAGE

 

 

Handle

 

knob

 

Lower handle

16

Image 16
Contents Rotary Lawn Mower Table of Contents Safety RulesGeneral Service III. ChildrenIV. Safe Handling of Gasoline Do notWarranty Limited WarrantyProduct Specifications AccessoriesHOW to SET UP Your Mower Assembly / PRE-OPERATIONToremovemowerfromcarton Meets Cpsc Safety Requirements OperationKnow Your Lawn Mower Starting a cold engineHOW to USE Your Lawn Mower To Empty Grass Catcher Side DischargingTo Convert Mower Rear BaggingTo Stop Engine Before Starting EngineTo Start Engine Mowing Tips Mulching Mowing TipsMaintenance Lubrication ChartGeneral Recommendations Before Each USELawn Mower Engine AIR FilterMuffler Spark PlugService and Adjustments CleaningRear Deflector To Remove Drive BeltTo Adjust Handle StorageCarburetor HandleProblem Cause Correction OtherFuel System Engine OILQualified service center Catcher not venting air Clean grass catcherBelt off of pulley Check/reinstall drive belt Worn, bent or loose blade Replace blade. TightenRepair Parts KEY Part Description Page 532 40 532 41 44-89 Rev 05.01.07 by