Husqvarna 340, 345, 350 manual KEY to Symbols

Page 2

KEY TO SYMBOLS

Symbols

CAUTION! Chain saws can be dangerous! Careless or incorrect use can result in serious or fatal injury to the operator or others.

Please read the instructions carefully and make sure you understand them before using the saw.

Always wear:

Approved protective helmet

Approved hearing protection

Protective glasses or visor

Both of the operator´s hands must be used to operate the chain saw. Please see page 30 in your "Chain saw operator´s safety manual".

Never operate a chain saw holding it with one hand only. Please see page 30 in your "Chain saw operator´s safety manual".

Contact of the guide bar tip with any object should be avoided. Please see pages 12-21 in your "Chain saw operator´s safety manual".

Tip contact may cause the guide bar to move suddenly upward and backward, which may cause serious injury. Please see pages 12-21 in your "Chain saw operator´s safety manual".

Switch off the engine by moving the stop switch to the STOP position before carrying out any checks or maintenance.

Always wear approved protective gloves.

Regular cleaning is required.

Visual check.

Protective glasses or a visor must be worn.

Refuelling

Chain oil and chain oil flow adjustment

2 – English

Image 2
Contents 340/345/350 101 90KEY to Symbols SymbolsContents Safety Instructions Chain SAW Safety EquipmentChain brake and front hand guard Right hand guard Throttle lockChain catcher Muffler Stop switchVibration damping system Checking the inertia brake release Checking brake band wearChecking the front hand guard Checking the brake triggerThrottle lock Cutting Equipment 5 basic rulesSaw chain Cutting equipment designed to minimise kickbackBar Some terms that describe the bar and chainSharpening cutting teeth Sharpening your chain and adjusting raker clearanceGeneral information on sharpening cutting teeth Tensioning the chain General advice on setting raker clearanceSetting the raker clearance Filling with chain oil Lubricating cutting equipmentChain oil Never use waste oilChecking wear on cutting equipment Needle bearing maintenanceChecking chain lubrication Lubricating the bar tip sprocketHOW to Avoid Kickback What is kickback?Never use the saw one- handed General rulesDo not let go of the handles 10 ft General Safety PrecautionsMin m Basic safety rules General Working InstructionsTerms Basic cutting techniqueGeneral CuttingLimbing Tree felling techniqueSafe distance Felling directionClearing the trunk and preparing your retreat FellingCutting the trunk into logs General adviceFreeing a tree that has fallen badly = high accident risk Freeing a Trapped treeWhat is WHAT? What is what?340 AssemblyMounting guide bar and chain 345/350Fuel Handling Fuelmix10ft FuellingMin 3 m Start Start and StopStart and stop StopMaintenance CarburetorChanging a broken or worn starter cord Starter device assemblyStarter device Tensioning the recoil springAir filter Needle bearing maintenanceAdjustment of the oil pump MufflerCooling system Centrifugal cleaning Air InjectionTemperature -5C or colder Winter useMonthly maintenance Weekly maintenanceDaily maintenance Technical Data 340 345 350Federal and California Emission Control Warranty Statement Your Warranty Rights Obligations1998W48
Related manuals
Manual 4 pages 16 Kb