CONTROLS
Blade Control Lever
To engage the mower blades, slowly lift the lever up and into the the lock notch.
WARNING!
No adjustments or maintenance to be carried out unless:
•the engine stopped
•the ignition key removed
•the parking brake activated
Manual Transport
When pushing or pulling the mower, be sure to engage the EZT Hydrogear bypass linkages. The EZT bypass linkages are located on the rear of the frame, below the rear engine guard.
•Raise the deck into the highest cutting position.
•Pull the EZT bypass linkages out and into the slots. Release linkages to hold in the bypass position.
•Release park brake.
•To reengage the EZT’s to drive, reverse the above procedure.
Mower deck blade control lever in the disengaged position
Set bypass linkages into slots on both sides
22