Husqvarna YTH1842XP owner manual Install Seat See Fig

Page 7

ASSEMBLY

Use terminal access doors for:

•Inspection for secure connections (to tighten har dware).

•Inspection for corrosion.

•Testing battery.

•Jumping (if required).

•Periodic charging.

SEAT

SEAT PAN

SHOULDER

BOLT

DISCARD

TERMINAL PROTECTIVE CAPS

TERMINAL

ACCESS

DOOR

02180

KEPS

HEX BOLT

NUT

 

POSITIVE (RED)CABLE

NEGATIVE (BLACK)CABLE

02466

FLAT WASHER

ADJUSTMENT

02464

KNOB

 

FIG. 3

FIG. 2

INSTALL SEAT (See Fig. 3)

Adjust seat before tightening adjustment knob.

•Remove adjustment knob and fl at washer securing seat to cardboard packing and set aside for assembly of seat to tractor.

•Pivot seat upward and remove from the cardboard pack- ing. Remove the cardboard packing and discard.

•Place seat on seat pan so head of shoulder bolt is positioned over large slotted hole in pan.

•Push down on seat to engage shoulder bolt in slot and pull seat towards rear of tractor.

•Pivot seat and pan forward and assemble adjustment knob and flat washer loosely. Do not tighten.

•Lower seat into operating position and sit on seat.

•Slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down.

•Get off seat without moving its adjusted position.

•Raise seat and tighten adjustment knob securely.

NOTE: You may now roll or drive your tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid.

TO ROLL TRACTOR OFF SKID (See Op- eration section for location and function of controls)

•Press lift lever plunger and raise attachment lift lever to its highest position.

•Release parking brake by depressing brake pedal.

•Place freewheel control in "transmission disengaged position" (See “TO TRANSPORT” in the Operation section of this manual).

•Roll tractor forward off skid.

•Remove banding holding the deflector shield up against tractor.

TO DRIVE TRACTOR OFF SKID (See Op- eration section for location and function of controls)

WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects.

•Be sure all the above assembly steps have been com- pleted.

•Check engine oil level and fill fuel tank with gasoline.

•Place freewheel control in "transmission engaged" position (see "TO TRANSPORT" in Operation section of this manual).

•Sit on seat in operating position, depress brake pedal and set the parking brake.

•Place motion control lever in neutral (N) position.

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents YTH1842XP II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIII. Children ServiceIV. Towing Table of Contents Steering Wheel Gauge Wheels Unassembled PartsBefore Removing Tractor from Skid AssemblyTools Required for Assembly To Remove Tractor from CartonInstall Seat See Fig Check for Proper Position of ALL Belts Assemble Gauge Wheels to Mower Deck See FigCheck Tire Pressure Check Mower LevelnessOperation Know Your Tractor To USE Cruise Control HOW to USE Your TractorTo Transport See Figs To Adjust Gauge Wheels See FigTo Operate Mower See Fig To Operate on HillsADD Gasoline Before Starting the EngineTowing Carts and Other ATTACH- Ments Check Engine OIL LevelMowing Tips Purge TransmissionGeneral Recommendations MaintenanceBefore Each USE Tractor Engine Cleaning To Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig To Level Mower HousingTo Replace Mower Blade Drive Belt See Fig Recheck measurements after adjustingTo Replace Motion Drive Belt See Fig To Check and Adjust Brake See FigFront Wheel TOE-IN/CAMBER Transmission REMOVAL/EPLACEMENTTo Adjust Steering Wheel Alignment To Start Engine with a Weak Battery See FigTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsWith attachment clutch Tractor Model NO. YTH1842XP 96011008300, Product no 11 SchematicElectrical KEY Part NO. NO. Description Chassis and Enclosures Repair Parts Tractor Model NO. YTH1842XP 96011008300, Product no 11 KEY Part Description DriveSteering Assembly KEY Part NO. NO. Description Optional Equipment EngineSeat Assembly Wheels & Tires DecalsMower Lift Mower Deck Repair Parts Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationRantywar Tementsta 532 19 63-26 12.03.04 RD
Top Page Image Contents