Husqvarna YTH2042 Unassembled Parts, Tools Required for Assembly, Toremovetractorfromcarton

Page 5

UNASSEMBLED PARTS

Keys

Slope Sheet

 

(1) Oil Drain Tube

For Future Use

(2) Keys

ASSEMBLY

Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes.

TOOLS REQUIRED FOR ASSEMBLY

A socket wrench set will make assembly easier. Standard wrench sizes are listed.

(1)

1/2" wrench

Tire pressure gauge

 

(2)

7/16" wrenches

Utility knife

Pliers

When right or left hand is mentioned in this manual, it means when you are in the operating position (seated behind the steering wheel).

TOREMOVETRACTORFROMCARTON

UNPACK CARTON

•Remove all accessible loose parts and parts cartons from carton .

•Cut along dotted lines on all four panels of carton. Remove end panels and lay side panels flat.

•Check for any additional loose parts or cartons and remove.

BEFORE REMOVING TRACTOR FROM SKID

TO CHECK BATTERY (See Fig. 1)

•Lift seat to raised position.

NOTE: If this battery is put into service after month and year indicated on label (label is located between terminals) charge battery for minimum of one hour at 6-10 amps. (See "BATTERY" in Maintenance section of this manual for charging instructions).

•For battery and battery cable installation see "RE- PLACING BATTERY" in the "Service and Adjustments" section in this manual.

LABEL

Fig. 1

5

ADJUST SEAT (See Fig. 2)

•Sit in seat.

•Lift up adjustment lever (A) and slide seat until a com- fortable position is reached which allows you to press clutch/brake pedal all the way down.

•Release lever to lock seat in position.

A

Fig. 2

NOTE: You may now roll your tractor off the skid. Follow the instructions below to remove the tractor from the skid.

WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects.

TO ROLL TRACTOR OFF SKID (See Operation section for location and function of controls)

•Raise attachment lift lever to its highest position.

•Releaseparkingbrakebydepressingclutch/brakepedal.

•Place freewheel control in "transmission disengaged" position (See “TO TRANSPORT” in the Operation section of this manual).

•Roll tractor forward off skid.

•Remove banding holding the deflector shield up against tractor.

Continue with the instructions that follow.

Page 4 Page 6
Image 5
Page 4 Page 6
Contents YTH2042 Safe Operation Practices for Ride-On Mowers Safety RulesNever allow children to operate the machine III. ChildrenTable of Contents Tools Required for Assembly AssemblyUnassembled Parts ToremovetractorfromcartonCheck Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor To SET Parking Brake See Fig HOW to USE Your TractorStopping See Fig To USE Throttle Control D See FigTo Adjust Gauge Wheels See Fig To Adjust Mower Cutting Height See FigTo Operate Mower To Stop Mower BladesBefore Starting the Engine Automatic Transmission Warm UP Mowing TipsPurge Transmission Maintenance MaintenanceGeneral Recommendations ScheduleTractor BatteryBlade Care Blade Removal See FigEngine Deck Washout Port See Fig CleaningIN-LINE Fuel Filter See Fig To Remove Mower See Fig Service and AdjustmentsTo Install Mower See Install belt on engine pulley M, in belt keepers G To Level Mower To Replace Mower Blade Drive Belt See Fig Belt InstallationTo Check Brake To Replace Motion Drive Belt See FigTo Start Engine with a Weak Battery See Fig Transaxle Motion Control Lever Neutral Adjustment See FigTo Remove Wheel See Fig Front Wheel TOE-IN/CAMBERTransmission Other StorageFuel System Engine OILTroubleshooting Battery will not To run when operFires when turn Engine continuesWheels and Tires DecalsOptional Twin CYL. Engines SchematicElectrical KEY Part Description Chassis Tractor - Model Number YTH2042 96043010602, Product no 43 Drive Tractor - Model Number YTH2042 96043010602, Product no 43 111 113 109 EngineEngine Power Rating Information Steering Assembly Tractor - Model Number YTH2042 96043010602, Product no 43 Mower Deck 532 40 Mower Housing 532 19 51-81 Link Asm Lift LH Rear Mower Lift532 42 Seat Seat AssemblyService Notes Suggested Guide for Sighting Slopes for Safe Operation 02.20.12 BD
Related manuals
Manual 44 pages 63.7 Kb
Top Page Image Contents