Husqvarna 327RJx manual Assembly, Fitting the J-handle, Assembling the cutting equipment

Page 12

ASSEMBLY

Fitting the J-handle

•Clip the loop handle onto the shaft. Note that the loop handle must be fitted between the arrows on the shaft.

•Slide the spacer into the slot in the loop handle.

•Fit the nut, knob and screw. Do not overtighten.

•Attach the J-handle to the loop handle using the three screws, as shown.

•Now adjust the trimmer to give a comfortable working position. Tighten the bolt/knob.

WARNING! Only grass blades/grass

! cutters or trimmer heads/plastic blades may be used when the J-handle is fitted. Saw blades must never be used with the J-handle.

Assembling the cutting equipment

WARNING! When fitting the cutting

! attachment it is extremely important that the raised section on the drive disc/ support flange engages correctly in the centre hole of the cutting attachment. If the cutting attachment is fitted incorrectly it can result in serious and/or fatal personal injury.

WARNING! Never use a cutting

! attachment without an approved guard. See the chapter on Technical data. If an incorrect or faulty guard is fitted this can cause serious personal injury.

IMPORTANT! If a saw blade or grass blade are to be used the machine must be equipped with the correct handlebar, blade guard and harness.

Fitting the blade guard/ combination guard, grass blade and grass cutter

•Hook the blade guard/combination guard (A) onto the fitting on the shaft and secure with the bolt.

12 – English

Page 11 Page 13
Image 12
Page 11 Page 13
Contents 327RJX-series KEY to Symbols SymbolsOperator of the machine must Ensure, while working, that no Persons or animals come closerContents Introduction Dear customerWhat is WHAT? What is what on the trimmer?General Safety Precautions Personal protective equipmentMachine′s safety equipment Throttle lockoutStop switch Cutting attachment guardVibration damping system MufflerLocking nut Cutting equipment Cutting equipmentSharpening grass cutters and grass blades General rulesTrimmer head Assembly Fitting the J-handleAssembling the cutting equipment Fitting other guards and cutting attachments Fuel safety Fuel HandlingFuel Fueling MixingStarting and Stopping Check before startingStarting and stopping StartingStopping Starter cord around your handBasic safety rules Working TechniquesGeneral working instructions Grass clearing using a grass blade Basic working techniquesGrass trimming with a trimmer head TrimmingCutting SweepingMaintenance CarburetorFine adjustment of the idle speed T Correctly adjusted carburetorLow speed jet L High speed jet HMuffler Cooling systemSpark plug Screen is damaged it should be replacedCleaning the air filter Air filterBevel gear Oiling the air filterMaintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical dataYour Warranty Rights and Obligations Emission Warranty Parts List Page S35 2,7mm 095-.106 25 m 15 cm T35, T35x T25 Page Page 1150990-95
Top Page Image Contents