Knoll Systems MR64 operating instructions Zone, Off, Source, RB8 Remote Layout

System

Off

Volume Up/Down Press and hold for continuous volume changes

Mute: Mutes music. to restore, press mute, input 1-4 or volume up/down

System

Off

System

Off

Changing Sources. To change to another source press and release the MR64 keypad INPUT button followed by the UP or DOWN button to scroll through the four sources until the desired source is displayed on the MR64 display. The amplifier for this room will then switch to this source.

To change sources in this room only from the RB8 remote control simply press the 1, 2, 3 or 4 button to directly go to the desired source.

Volume Up and Down: To adjust the volume up or down (always) first press the MR64 VOL button then quickly press the UP or DOWN button until the desired changed volume level is reached on the MR64. Holding the button gives continuous changes. After the UP or DOWN button has been released the MR64 keypad may display the current relative volume setting of low, mid, high etc.

To change the volume using the RB8 remote press the UP or DOWN button until the desired changed volume level is reached on the MR64. Holding the button gives continuous changes. After the UP or DOWN button has been released the MR64 keypad may display the current relative volume setting of low, mid high etc.

Mute: Momentarily press the MR64 keypad or RB8 remote MUTE

button. The LCD display willMute display:

To restore the sound press the MUTE, UP or DOWN button on the MR64 keypad or RB8 remote and the source selected when the mute button was first pressed and the former volume level is restored.

Turn Room Off: Momentarily
	Zone
press the MR64 keypad OFF button
or RB8 remote POWER button.	Off
The MR64 will display:

If any other room was turned on, only this room will shut off and other rooms will not be affected. If this was the only room turned on since the system was

♦To change all rooms to the same source, this room must be listening to a source first. Press the ALL button, quickly press the INPUT button then the UP or DOWN button until the desired source is displayed on the LCD display. All of the rooms will be now be playing that source at about 30% volume.

Note: Be very careful when turning up the whole house volume. The volume levels increase together, but rooms with their volume already set high may damage equipment when their volume is increased.

♦To change the whole house volume, this room must be listening to a source first. Press the ALL button, quickly press the VOL button then the UP or DOWN button until the desired volume in all rooms is achieved. Please note all rooms will not necessarily be at the same volume as some may have initially been at a higher or lower volume and had the volume changed from that point. The whole house volume changes more gradually than when changing individual room volumes.

♦To turn the whole home system off (except for sources), press the ALL button then quickly press the OFF button. The whole system will start its turn off

procedure. The LCD keypad will display:

Another way to achieve turning the whole system off is to press the MR64 OFF button for about 5 seconds. To turn the whole home system off from the RB8 remote control, press the POWER button for about 5

seconds. The MR64 keypad will then display:

RB8 Remote Layout

first turned on, then the whole system will shut off and the MR64 will display a few seconds later:

Sources may have to be turned off manually or by remote.

ALL System Commands

The ALL button is used to change the whole house volume (only for rooms already turned on), select one source for all rooms or turn all rooms off.

Power: switches room off or whol house off(press for 5 seconds)

Input 1-4: Turns on room and selects input music source

POWER

1 2

34

INPUT

systems

MUTE

+

VOL

-

RB8

All commands are from the MR64 keypads only and cannot be done from the remote control.

2002-2005 Knoll Systems. All rights reserved v1.0

Source xxxx