Husqvarna YTH22V46 owner manual Install belt on engine pulley M, in belt keepers G

Page 19

SERVICE AND ADJUSTMENTS

•ATTACH MOWER SIDE SUSPENSION ARMS (A) TO CHASSIS - Position hole in arm over pin (B) on outside of tractor chassis and secure with retainer spring.

•Repeat on opposite side of tractor.

A

B

Fig. 21

•ATTACH REAR LIFT LINKS (C) - Lift rear corner of mower and position slot in link assembly over pin (D) on rear mower bracket and secure with washer and retainer spring.

C

D

Fig. 22

•Insert end of link (E) into hole in front mower bracket and secure with washer and retainer spring (J).

E

FJ

H

Fig. 23

•Hook end of clutch cable spring (Q) into hole in idler arm (R).

•Push clutch cable housing guide (P) into bracket, slide collar (L) onto guide and secure with retainer spring (K).

•Install belt on engine pulley (M), in belt keepers (G).

M

Fig. 24

IMPORTANT: CHECK BELT FOR PROPER ROUTING IN ALL MOWER PULLEY GROOVES.

•Raise attachment lift lever to highest position.

•If necessary, adjust gauge wheels before operating mower as shown in the Operation section of this manual.

•ATTACH FRONT LINK (E) - Work from left side of trac- tor. Insert rod end of link assembly through front hole in tractor front suspension bracket (F).

R

Q

G MF

G

A E

P

B

C

K
L D	Fig. 25

19

Image 19

Contents YTH22V46 II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceGeneral Service III. ChildrenTable of Contents To Remove Tractor from Carton AssemblyTools Required for Assembly Unassembled PartsCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor To USE Throttle Control D See Fig HOW to USE Your TractorTo SET Parking Brake See Fig Stopping See FigTo Operate Mower To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To USE Cruise Control J See FigTo Operate on Hills Service REMINDER/HOUR MeterUsing the Reverse Operation System Reverse Operation System ROSTo Start Engine See Fig Before Starting the EngineCheck Engine OIL Level ADD GasolinePurge Transmission Mowing TipsSchedule MaintenanceMaintenance General RecommendationsBlade Removal See Fig BatteryTractor Blade CareEngine Deck Washout Port See Fig CleaningMuffler IN-LINE Fuel Filter See FigTo Remove Mower See Fig To Install Mower See FigInstall belt on engine pulley M, in belt keepers G To Level Mower To Replace Motion Drive Belt See Fig Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Check BrakeFront Wheel TOE-IN/CAMBER To Start Engine with a Weak Battery See FigReplacing Battery See Fig To Remove Wheel See FigTransmission Cylinders OtherFuel System Engine OILProblem Cause Correction TroubleshootingEngine continues Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe Operation04.06.10 JA