Philips 100WT10P manual To test your double-tap pattern, To recalibrate the stylus tapping pattern

Page 10

4 DATA INPUT TO THE TOUCH SCREEN

8

4.1.2 Tap settings

You can use the stylus to tap or double-tap.

Each user's tapping pattern is different.The 100WT10P system setup process 'learns' each new user's tapping pattern 'signature'.

To test your double-tap pattern:

1.Tap START

2.Tap SETTINGS

*Tap CONTROL PANEL

3. Double tap STYLUS

4. Choose the DOUBLE-TAP

5. Follow the onscreen instructions

To recalibrate the stylus tapping pattern:

1.Tap START

2.Tap SETTINGS

3.Tap CONTROL PANEL

4.Double tap STYLUS

5.Choose the CALIBRATION

6.Tap RECALIBRATION

7.Follow the onscreen instructions

Image 10

Contents Page Table of Contents Introduction Before YOU BeginPacking list Left View Physical AppearanceRight View BottomMini-VGA to VGA Cable Front ViewBase Station Ruggedized DesignWlan setup Base station setupLoad battery Getting Started Power Supply BatteryTo make changes to power saving setup Stylus Data Input to the Touch ScreenTo close Transcriber To test your double-tap pattern To recalibrate the stylus tapping patternOn-Screen Keyboard Method One Connecting to a NetworkWlan Method TwoLAN Data Synchronization USBOn your 100WT10P to setup for IR Microsoft Internet Explorer Featured Software ApplicationsControl Panel ActiveSyncTo launch VGA utility Registry Utility Wordpad100WT10P will not turn on… TroubleshootingMy system does not run smoothly… When I use the stylus pen… How do I turn off my 100WT10P?How do I use the on-screen keyboard? Is MS Transcriber supported by RDP?Is Cisco Leap supported? To clean the screen Safety and Product Care InstructionsTo clean the case Appendix a Specifications Network StorageFax/Modem MultimediaAppendix C Proprietary Notice and Liability Disclaimer CE Declaration of Conformity Removable BatteryFederal Communications Commission FCC Notice FCC Radiation Exposure Statement Appendix D Regulatory InformationFCC Warning ESD WarningTo change a fuse in this type of plug proceed as follows How to connect a plugInformation for UK only End-of-Life Disposal3138 105 M73-PLPOA-130