6 DATA SYNCHRONIZATION | 12 |
To share information between your 100WT10P and your PC/Laptop, you need to establish a direct PC con nection.
There are two ways to make direct connection. One way is through USB interface; the other is IR transmis sion.
To start a connection to a host PC, you need to start the ActiveSync application. ActiveSync is installed in your 100WT10P when shipped. Before set up a connection to your host PC, you also need install ActiveSync 3.7 (or higher) on the host PC.To download this freeware, go tohttp://www.microsoft.com and search for ActiveSync download.
6.1USB
You can use USB cable to connect to a host PC. A Mini USB B to A cable is used as the synchronization cable.
Figure A illustrates use of the Mini USB B to A cable. It connects the 100WT10P to a host PC. When the cable connection is ready, setup for PC connection:
1.Tap on START |
|
2.Tap on SETTINGS |
|
Fiture A | |
3.Tap on CONTROL PANEL |
|
| |
4.Tap on the PC CONNECTION |
|
5. Check the box:Allow connection |
|
with desktop or laptop |
|
computer when device is |
|
attached. (When you first start |
|
the system, the default connection |
|
is USB to PC).Then start |
|
the ActiveSync application |
|
1.Tap on START |
|
2.Tap on PROGRAM |
|
3.Tap on ACTIVESYNC |
|
NOTE: To restart ActiveSync after |
|
it has been stopped, unplug the |
|
USB cable from the host PC and |
|
then plug it in again. |
|
see Fiture A |
|