Philips manual On your 100WT10P to setup for IR

Page 15

6 DATA SYNCHRONIZATION

6.2IR

You can connect to host PC with IR (Infrared) transmission . Place your 100WT10P and the target device in line of sight of each other and at a distance of no more than one meter.

On your 100WT10P to setup for IR

1.Tap START

2.Tap SETTINGS

3.Tap CONTROL PANEL

4.Tap the PC CONNECTION

5.Check the box:Allow connection with desktop computer when device is attached.

6.Tap CHANGE

7.In the pull-down menu, choose IR to PC

8.Tap OK

Then start the ActiveSync application

1.Tap on START

2.Tap on PROGRAM

3.Tap on ACTIVESYNC

The host PC will detect the 100WT10P and initiate a connection.

Image 15

Contents Page Table of Contents Before YOU Begin IntroductionPacking list Bottom Physical AppearanceRight View Left ViewRuggedized Design Front ViewBase Station Mini-VGA to VGA CableGetting Started Base station setupLoad battery Wlan setupBattery Power SupplyTo make changes to power saving setup Data Input to the Touch Screen StylusTo close Transcriber To recalibrate the stylus tapping pattern To test your double-tap patternOn-Screen Keyboard Method Two Connecting to a Network Wlan Method OneLAN USB Data SynchronizationOn your 100WT10P to setup for IR ActiveSync Featured Software ApplicationsControl Panel Microsoft Internet ExplorerTo launch VGA utility Wordpad Registry UtilityTroubleshooting 100WT10P will not turn on…My system does not run smoothly… How do I turn off my 100WT10P? When I use the stylus pen…Is MS Transcriber supported by RDP? How do I use the on-screen keyboard?Is Cisco Leap supported? Safety and Product Care Instructions To clean the screenTo clean the case Appendix a Specifications Multimedia StorageFax/Modem NetworkAppendix C Proprietary Notice and Liability Disclaimer Removable Battery CE Declaration of ConformityFederal Communications Commission FCC Notice ESD Warning Appendix D Regulatory InformationFCC Warning FCC Radiation Exposure StatementEnd-of-Life Disposal How to connect a plugInformation for UK only To change a fuse in this type of plug proceed as follows3138 105 M73-PLPOA-130