How do I turn off my 100WT10P?

8 TROUBLESHOOTING

8.3 How do I turn off my 100WT10P?

To end operation: Go to the power switch under the orange protective cover on the lower left side. Or tap on the Start Menu and then choose "Suspend" to turn off the pad.

NOTE: This places the pad in standby mode. Unlike a PC, your 100WT10P is actually in "suspend" mode rather than "power off" when it's turned off. It's the feature to allow user to quick resume operation. Your data and files remain in the memory as long as the battery is charged.

8.4How do I reset the unit when the system freezes or hangs up… 8.4.1

Software reset.

a.Push the Reset latch located in the rear of the pad underneath the Modular Connector so you can see the Software Reset button.

b.Press the Software Reset with the tip of the stylus.

8.4.2

Hardware reset. Backup your data first then press Hardware Reset button.

CAUTION: A Hardware reset erases all data in 100WT10P. (Only data in IPSM remains after a hardware reset)

NOTE: 1.If you would like to back up the registry data to avoid the data loss when battery is out of charge by accident, go to Control panel, tap on RegUtility, then choose BackUp Registry. A backup copy of your registry data will be stored in the reserved partition.When the unit is rebooted after a hardware reset, the system will retrieve the registry data being saved in the IPSM.

2.It is also possible to keep a backup copy of other critical data in the IPSM to avoid unexpected data loss. Up to 28 MB memory storage is available in IPSM.

8.5When I use the stylus pen… 8.5.1

The stylus pen does not respond to my handwriting.

By default, the stylus operates in the tap mode. In order to use the handwriting input, you need to launch the handwriting recognition application. Microsoft Transcriber is used for 100WT10P.

1.Tap START

2.Tap PROGRAMS

3.Tap TRANSCRIBER

4.Transcriber launches and an dialogue box pops-up

5.The icon is displayed on the system tray at the bottom of screen

6. Read Help to learn how to use

the handwriting input; tap OK when finished

8.5.2

To return to the tap mode:

1. Double tap on the Transcriber icon .

2. Choose Close Transcriber

8.5.3

System does not respond to taps…

1.Try a single solid tap.

2.Try a double tap instead of single tap.

3.Try tapping the center of an icon.

4.Recalibrate the tapping pattern.

NOTE: You might need to practice a couple of time in to operate your screen with taps.