Connections
Connecting to the Network
Wireless NetworkYou can connect to the network with a Wireless IP sharer.
1.A wireless AP/IP router is required to make a wireless network connection. Connect the wireless LAN adapter to the Wireless LAN Adapter on the rear panel of the product.
-This unit is compatible with the supplied Wireless LAN Adapter.
-You can also use the wireless network by connecting the Wireless LAN Adapter Gender to the Wireless LAN Adapter.
2.Set the network options. (See page 35)
Broadband service
Wireless IP sharer
iPod
PC
| OR | |
Networking with PC for |
| |
AllShare function | Wireless LAN Adapter | |
(See pages 58~59) | ||
|
✎NOTE
You must use a wireless IP sharer that supports IEEE 802.11 a/b/g/n. (n is recommended for stable operation of the wireless network.)
Wireless LAN, in its nature, may cause interference, depending on the use condition (AP performance, distance, obstacle, interference by other radio devices, etc).
Set the wireless IP sharer to Infrastructure mode.
When applying the security key for the AP (wireless IP sharer), only the following is supported.
1)Authentication Mode : WEP, WPAPSK, WPA2PSK
2)Encryption Type : WEP, AES
For the AllShare function, a PC must be connected in the network as shown in the figure.
Connecting the FM Antenna
iPod
FM Antenna (supplied) 1. Connect the FM antenna supplied to the FM Antenna Jack.
2.Slowly move the antenna wire around until
you find a location where reception is good, then fasten it to a wall or other rigid surface.
✎NOTE