Samsung HT-D5530 Installing the Speakers on the Tallboy Stand, Connecting The Speakers, CAUTION, !CAUTION, Subwoofer, Centre Speaker, Front Speaker (L), Front Speaker (R)

Installing the Speakers on the Tallboy Stand

Connections 02

*HT-D5530 only - Front Speakers*HT-D5550 only - Front/Surround Speakers1.Turn the Stand Base upside-down and connect it to the Stand.

2.Insert small screws (4x20, For connecting Stand & Stand Base) clockwise into the four holes marked using a screwdriver as shown in the illustration.

!CAUTION

When you use a torque screwdriver, be careful not to put excessive force. Otherwise, it runs idle or can be damaged. (torque screwdriver- below 15 kg.f.cm)

3.Connect the upper Speaker to the assembled Stand.

4.Insert another large screw (5x15, For connecting Speaker & Stand) clockwise into the hole on the rear of the speaker using a screwdriver.

5.This is the appearance after the speaker is installed. Follow this steps to install other speaker.

Connecting The Speakers

1

3

5

Stand

Base

Stand

Speaker

Stand

or

2

4

1. Press down the terminal tab on the back of the speaker.

2. Insert the black wire into the black terminal (–) and the red wire into the red terminal (+), and then release the tab.

3. Connect the connecting plugs to the back of the product by matching the	Black	Red
colours of the speaker plugs to the speaker jacks.

In case of HT-D5500

Front Speaker (L)				Surround Speaker (L)
	SPEAKERS OUT			Front Speaker (R)
	CENTER	FRONT	SURROUND
Centre Speaker
	SUBWOOFER	FRONT	SURROUND	Surround Speaker (R)
	SPEAKER IMPEDANCE : 3
Subwoofer	ONENTT OUT	CENTER FRONT SURROUND
		SPEAKERS OUT
		SUBWOOFER FRONT SURROUND
	VIDEO OUT	SPEAKER IMPEDANCE : 3

* Refer to page 18 for the speakers of HT-D5530/HT-D5550.

English 19

HT-D5500_ELS_1226.indd 19 2011-12-26 ￿￿ 1:23:48