Samsung HT-DS100 Connectingthe FM and AM Antennas, Cooling Fan, FM antenna connection, AM antenna connection, to the AM and terminals, 1.Connect the AM loop antenna supplied

Connecting the FM and AM Antennas

If AM reception is poor, connect an outdoor AM antenna(not supplied).

AM Loop Antenna (supplied)

FM Antenna (supplied)	Snap the tabs on the loop into the
	slots of the base to assemble the
	AM loop antenna.

FM antenna connection1.Connect the FM antenna supplied to the FM 75ΩCOAXIAL terminal as a temporary measure.

2.Slowly move the antenna wire around until you find a location where reception is good, then fasten it to a wall or other rigid surface.

•If reception is poor, connect an outdoor antenna. Before attaching a 75Ω coaxial cable (with a standard type connector), disconnect the supplied FM antenna.

AM antenna connection1.Connect the AM loop antenna suppliedto the AM and terminals.

2.If reception is poor, connect an outdoor single vinyl-covered wire to the AM terminal. (Keep the AM loop antenna connected).

Cooling Fan

IMPEDANCE SUBWOOFER : 3Ω

FRONT / CENTER / REAR : 6Ω

CENTER	REAR	FRONT
	L	L
SUBWOOFER	REAR	FRONT
	R	R

13

The cooling fan dissipates the heat generated inside the unit so that the unit can be operated normally. The cooling fan is activated automatically to supply cool air to the unit.

Please observe the following cautions for your safety.

•Make sure the unit is well-ventilated. If the unit has poor ventilation, the temperature inside the unit could rise and may damage it.

•Do not obstruct the cooling fan or ventilation holes. (If the cooling fan or ventilation holes are covered with a newspaper or cloth, heat may build up inside the unit and fire may result.)