Signal outputs and frequency responses from the speakers will automatically be adjusted according to your speaker configuration and whether certain speakers are used or not.
| Setting the Test Tone | GB |
|
Use the Test Tone feature to check the speaker connections.
1
3
In Stop mode, press MENU button.
In the Speaker Setup, press the ENTER button again.
Press Cursor
‘Audio’ and then press ENTER button.
Press Cursor
4 to the desired speaker and then press ENTER button.
•For C, SL, and SR, each time the button is pressed, the mode switches alternately as follows: SMALL ➝ NONE.
•For L and R, the mode is set to SMALL.
1 | In | Stop or no disc |
| 2 | Press Cursor | |||||
| button to move to | |||||||||
|
|
|
|
| ||||||
|
| mode, press |
|
|
| |||||
|
|
|
|
| ‘Audio’ and then | |||||
|
| MENU button. |
|
|
| |||||
|
|
|
|
| press ENTER button. | |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Press RETURN button to return to the previous level.
Press MENU button to exit the setup screen.
3 | Press Cursor button | |
to move to ‘TEST | ||
| ||
| TONE’ and then press | |
| ENTER button. |
•The test tone will be sent to L ➝ C ➝ R ➝ SR ➝ SL ➝ SW in order.
If the ENTER button is pressed again at this time, the test tone will stop.
SETUP
Alternate method: press the TEST TONE button on the remote.
Press TEST TONE button.
L: Front Speaker (L) | C: Center Speaker | SW: Subwoofer |
R: Front Speaker (R) | SL: Rear Speaker (L) | SR: Rear Speaker (R) |
SMALL : Select this when using the speakers.
NONE : Select this when no speakers are connected.
Note
•Depending on PRO LOGIC and STEREO settings, the speaker mode may vary (see page 61).
•Test tone will be produced as follows:
When playing a DVD or CD, this will work only in Stop mode.
•Use this function to check that each speaker is correctly connected and that there is no problem.
To end the test tone,
press TEST TONE button again.
Start |
51 | 52 |