Samsung MAX-DN55 MAXDN55RH/ELS, MAXDN55RH/XEU Where to Install Your, Inserting Remote Control Batteries, Mini-CompactSystem, Connecting your System to the, Power Supply

Where to Install Your	Inserting Remote Control Batteries
Mini-Compact System

To take full advantage of your new mini-compact system, follow these installation instructions before connecting the unit.

Install the system on a flat, stable surface.

Never place this unit on carpeting.

Never place this unit in an outdoor area.

Maintain an open space of approximately 4 inches (10 cm) on the sides and rear of the system, for ventilation purposes.

Make sure that you have enough room to open the compact disc compartment easily.

Place the loudspeakers at a reasonable distance on either side of the system to ensure good stereo sound.

Direct the loudspeakers towards the listening area.

For optimum performance, make sure that both speakers are placed at an equal distance above the floor.

Disc 1

Disc 2

Disc 3

Disc Change

Disc Selection / Direct Play

Volume

+

On/Standby

R

Demo

Timer

Timer

On/Off

/Clock

–

DOLBY DIGITAL

TUNER

DVD/CD

TAPE

AUX

Band

d

Mono/ST Memory

CD Synchro Display

Deck 1/2

REV. Mode

S

o

u

n

E

n

TAPE

TAPE REC

/

r

P

REC/Pause

Normal

HI-Speed

D

S

P

/

E

MIC Mixing

REC Lock

Down

Tuning Mode

Up

Q

Phones

Echo

S

.

B

a

ss

lby d

MIC1

MIC2

Dooun

Surr

Insert or replace remote control batteries when you:

Purchase the mini-compact system

Find that the remote control is no longer operating correctly

When replacing the batteries, use a new set of batteries and never mix alkaline and manganese batteries.

1 Place your thumb on the position marked on the battery compartment cover (rear of the remote control) and push the cover in the direction of the arrow.

2 Insert two AAA, LR03 or equivalent batteries, taking care to respect the polarities:

+ on the battery against + in the battery compartment.

– on the battery against – in the battery compartment.

3 Replace the cover by sliding it back until it clicks into position.

Connecting your System to the

Power Supply

The main lead must be plugged into an appropriate socket.

Before plugging your system into a main socket, you must check the voltage setting (OPTIONAL). If the voltage of the socket does not correspond to the setting on the rear of the unit, you may seriously damage your system.

1	Check the position of the voltage selector on the rear of the system
			GB
	(OPTIONAL).
2	Plug the main lead (marked AC Cord on the rear of the system) into
	an appropriate socket.
3	Press the On/Standby button to switch your mini-compact system on.
		S

7