Connecting the AM (MW)/LW Aerial
GB
The AM aerial (for long and medium waves) can be: Placed on a stable surface
Fixed to the wall (you must first remove the base)
The AM aerial connector terminals are located on the rear of the system and are marked AM .
To avoid noise interference, check that the loudspeaker wires do not run close to the aerial wires.
Always keep them at least 2 inches (5 cm) away.
ANTENNA
AC CORD
Connecting the FM Aerial
There are two types of aerials, follow the instructions below (depending on option chosen).
1 How to connect a COAXIAL TYPE areial. Connect a 75Ω antenna to the FM aerial terminal.
Plug the connector on the FM aerial supplied into the coaxial socket (75Ω ) marked FM (75Ω ) on the rear of the system.
Follow the instructions given on Page 13 to tune into a radio station, and determine the best position for the aerial.
If reception is poor, you may need to install an outdoor aerial.
To do so, connect an outdoor FM aerial to the FM socket on the rear of the system, using a 75Ω coaxial cable (not supplied).
FMFM
| | |
FM AERIAL | | 75Ω COAXIAL CABLE |
(supplied) | | (not supplied) |
| | |
2 How to connect a SCREW TYPE wire aerial (OPTIONAL). The FM aerial connector terminals are located on the rear of the system and marked FM(300Ω ).
Spread the T.form FM aerial out and attach the ends to a wall, in the position providing the best reception.