Samsung MM-G35 MM-G35R/EDC, MM-G35R/XEE Connecting your System to the Power Supply, Connecting the Loudspeakers, Where to InstallYour Micro-CompactSystem, Inserting Remote Control Batteries

Where to InstallYour Micro-Compact System

ENG

To take full advantage of your new micro-compact system, follow these installation instructions before connecting the unit.

Install the system on a flat, stable surface.

Never place this unit on carpeting.

Never place this unit in an outdoor area.

Maintain an open space of approximately 6 inches (15 cm) on the sides and rear of the system, for ventilation purposes.

Make sure that you have enough room to open the compact disc compartment easily.

Place the loudspeakers at a reasonable distance on either side of the system to ensure good stereo sound.

Direct the loudspeakers towards the listening area.

For optimum performance, make sure that both speakers are placed at an equal distance above the floor.

Connecting your System to the Power Supply

Before plugging your system into a main socket, you must check the voltage.

1 Plug the main lead into an appropriate socket.

2 Press the (STANDBY/ON) button to switch your micro-compact system .

AUX IN

T L

R

Inserting Remote Control Batteries

Insert or replace remote control batteries when you: Purchase the micro-compact system

Find that the remote control is no longer operating correctly

When replacing the batteries, use a new set of batteries and never mix alkaline and manganese batteries.

1	Place your thumb on the position marked	on the battery
	compartment cover (rear of the remote control) and pull the cover in
	the direction of the arrow.
2	Insert two AAA, LR03 or equivalent batteries, taking care to respect
	the polarities:

+on the battery against + in the battery compartment – on the battery against – in the battery compartment

3 Replace the cover by sliding it back until it clicks into position.

If you will not be using the remote control for a long time, remove the batteries to prevent corrosion.

The remote control can be used up to approximately 7 meters in

astraight line. It can also be operated at a horizontal angle of up to 30° from the remote control sensor.

Connecting the Loudspeakers

The loudspeaker connector terminals are located on the rear of the system.

There are two terminals on the system: left speaker (marked L)

right speaker (marked R)

To achieve the correct sound quality,insert those speaker connector cables to the speaker connector terminals of the system.

AUX IN

FM ANT L

75

R

6