Where to Install Your
Micro Component System
To take full advantage of your new micro component system, follow these installation instructions before connecting the unit.
| TUNER | Open/Close |
Standby/On |
|
|
| CD |
|
| TAPE |
|
Phones | AUX |
|
Full Auto Remote Control Operation
Connecting your System to the Power Supply
The main lead must be plugged into an appropriate socket.1 | Plug the main lead (marked AC Cord on the rear of the system) into |
| an appropriate socket. |
2 | Press the Standby/On button to switch your micro component system |
| on. |
Inserting Remote Control Batteries
GB
Insert or replace remote control batteries when you:1 | Place your thumb on the position marked | on the battery |
| compartment cover (rear of the remote control) and push the cover in | |
| the direction of the arrow. |
|
2 | Insert two AAA, LR03 or equivalent batteries, taking care to respect | |
| the polarities: |
|
| + on the battery against + in the battery compartment | |
| – on the battery against – in the battery compartment | |
3 | Replace the cover by sliding it back until it clicks into position. | |
| If you will not be using the remote control for long time, | |
| remove the batteries to prevent corrosion |
|
7