Samsung RS20BRPS TEMPERATURE CONTROL （RS20NR**）, TEMPERATURE CONTROL, INSTALLING REFRIGERATOR, OPERATING

INSTALLING REFRIGERATOR

Check the dimensions of your entrance door.

Check the dimensions of your entrance door to determine whether the refrigerator can pass through it.

*Dimension of the Appliance

	Dimension (mm)	Remarks
Width	855
Depth	756	With door
Height	1728	With hinge

Remove all packing materials：

Remove the foam pad for the appliance before using it.

Allow a clearance of 10cm to the right, left and rear side when installing the appliance; as this will help to reduce power consumption.

TEMPERATURE CONTROL （RS20NR**）

FRE. TEMP	REF. TEMP
	colder	LED No. ⑤
		LED No. ④
		LED No. ③
		LED No. ②
	cold	LED No. ①

FRE. TEMP BUTTON
To set the freeze temperature, push	REF. TEMP BUTTON	INSTRUCTIONS
the button repeatedly to select from	To set the refrigerator temperature, push
level 1 (cold) to level 9 (colder).	the button repeatedly to select from level
• The higher level you set, the lower temperature inside the unit.	1 (cold) to level 9 (colder).

Allow sufficient space to install the appliance on a flat surface.

If your appliance is not level, the internal cooling system may not work properly.

Over 10cm

Over 10cm

Store food in the refrigerator.

Wait for at least two or three hours after plugging your appliance in and before storing food and other articles inside.

Clean your refrigerator.

Wipe the inside and outside of your refrigerator with a dry cloth.

NOTE

FREEZE	Control Level Table				OPERATING
TEMPERATURE CONTROL
The freeze temperature can be set to any level from
level 1 (cold) to level 9 (colder).	Reference
Press FRE. TEMP button repeatedly until the		Cold	Normal		Colder
desired level is reached.	LED
- At each level, the LED indicators turn on or off as
shown on the table.	CONDITION
Refrigerator	(On)
	(Off)
The refrigerator temperature can be set to any level
	(Blink )
from level 1 (cold) to level 9 (colder).
Press REF. TEMP button repeatedly until the	Level	1 2 3	4 5	6 7	8 9
desired level is reached.
- At each level, the LED indicators turn on or off as	※ At level 2, 4, 6 and 8, LED marked with (				) will fully light
shown on the table.
	up after blinking for 5 seconds (			) .

For your convenience, your refrigerator temperature control has been preset in the。 factory.

NOTE	Refrigerator temperature controller shall be set as “NORMAL” (level 5: -20 for Freeze
	and 3 for Fridge if your refrigerator is installed first time or has been switched off for a long time.

When accidental power off happens and the power is reconnected, please check the status of temperature controller. User is suggested to set according to your actual application conditions and normal recommended setting is NORMAL.

12

5