Samsung RS21FANS Connect to the water supply line, For Exterior model, INSTALLING THE WATER DISPENSER LINE, expensive water damage, - Close the main water tap

INSTALLING THE WATER DISPENSER LINE

For Exterior model

Connect to the water supply line

Connect the water pipe with coupler and tap.			CAUTION
		The water line must be connect-
- Close the main water tap.
		ed to the cold water pipe.
- Connect coupler “A” to the tap.
		If it is connected to the hot
- Every join should be protected with sealing tape.		water pipe, it may cause the puri-
		fier to malfunction.
	WARRANTY INFORMATION
	This water line installation is not covered by the refriger-
	ator or ice maker manufacturer's warranty.
	Follow these instructions carefully to minimise the risk of	COUPLER “A”
	expensive water damage.

Note:

If the coupler does not fit on the current tap, go

the nearest authorised service dealer and purchase

the right couplers fittings. TAP

Select the location where the purifier is to install. (Model with the purifier)

-Cut the water line attached to the purifier to the appropriate place after measuring the distance between the purifier and the cold water tap.

-If you wish to reassemble the water inlet and outlet sides of the purifier during purifi- er installation, see the reference illustra- tion.

LINE

OUTLET

SIDE OF	90 degree
PURIFIER
	REFERENCE

PURIFIER

WATER

COUPLER

WATER INLET SIDE

OF PURIFIER

Remove any residual matter inside the purifier. (Model with the purifier)

-Open the main water tap to check whether water is running through the water tube on the water inlet side of the purifier.

-If water does not come out through the line, check whether the tap is open.

-Leave the tap open until clean water is running out and any residual matter that built up during manufacturing has been removed.

OUTLET SIDE

OF PURIFIER

PURIFIER

WATER LINE

WATER

30