Samsung RSA1ZHPE setting up your side-by-siderefrigerator, Secure the filter in position, Attach the filter lock stations

setting up your side-by-side refrigerator

E UP

Select the location where the filter is to install. (Model with the filter)

- If you wish to reassemble the water inlet and outlet sides of the filter during filter installation,

see the reference illustration.

-Cut the water line attached to the filter to the appropriate place after measuring the distance between the filter and the cold water tap.

LINE OUTLET

SIDE OF	90 degree
FILTER
FILTER WATER	REFERENCE

01TTINGS

WATER INLET	COUPLER
SIDE OF FILTER

Remove any residual matter inside the filter. (Model with the filter)

-Open the main water tap to check whether water is running through the water tube on the water inlet side of the filter.

-If water does not come out through the line, check whether the tap is open.

-Leave the tap open until clean water is running out and any residual matter that built up during manufacturing has been removed.

OUTLET SIDE	FILTER
OF FILTER
WATER	WATER LINE

Attach the filter lock stations.	TWO FILTER LOCK
	STATION

-Hold the filter lock stations in the appropriate position (under the sink for example) and fix it tightly into place where to screw.

TWO FILTER LOCK

STATION

Secure the filter in position.

-Fix the filter in position, as shown in the figure on the right.

WATER TUBE
FILTER	FILTER
	LOCK
	STATIONS
TIGHTENING
BAND

setting up _19