INSTALLATION
1.Press the SNAP FIT of the ADAPTOR in the HOUSING to open the ADAPTOR part, and then insert all external cables into the HOUSING. Secure the HOUSING on the PIPE or MOUNT by turning it clockwise.
(Secure two components tightly, to avoid loosened HOUSING.)PIPE OR | PIPE OR |
MOUNT | MOUNT |
HOUSING | HOUSING |
CABLE
ADAPTOR2.Connect external cables to the CONNECTORS(ALARM IN, POWER,
HOUSING
English
POWER INPUT ALARM OUT
INSULATION TUBE
ALARM IN RS-485 EXTERNAL
CABLE
ADAPTOR
M Then, wrap the BNC JACK with the INSULATION TUBE, and use an insulation tape to seal up the end of the INSULATION TUBE so that the BNC JACK does not protrude outside of the INSULATION TUBE coating.
For more information about cable connection, refer to Connecting the adaptor cable. (page 21)
English _13