Samsung SWA-9000S SWA-9000S/ZF 2. Check the standby status after plugging into an electrical outlet, Attach the Toroidal Ferrite Core to the Power Cord of the Soundbar

•• When connecting the speaker cables to the surround speakers, follow these steps:

1.Match the speaker cable connected to the grey jack to the speaker with the grey label.

2.Match the speaker cable connected to the blue jack to the speaker with the blue label.

3.Insert the red and black coloured ends of each speaker cable into the red and black jacks of the appropriate speaker.

•• The labels are on the backs of the speakers.

2. Check the standby status after plugging into an electrical outlet

Plug the Wireless Receiver Module power cord into an electrical outlet and into the Wireless Receiver Module to turn on the Wireless Receiver Module. The LINK LED indicator (blue LED) on the Wireless Receiver Module blinks. If the LED does not blink, refer to step 8 on page 11.

L	R
		STANDBY
SURROUNDSPEAKERSOUT		LINK
SPEAKERIMPEDANCE:3￿

IDSET

POWER

LINK

Blue blinking

POWER

Attach the Toroidal Ferrite Core to the Power Cord of the Soundbar

(Applicable only when connecting the SWA-9000S and MS series Soundbars/home cinemas.)

AC 100V~240V

4A~1.66A

POWER

OUT

(For TV)

POWER

IN

POWER	DIGITAL AUDIO IN
	(OPTICAL)	HDMI IN
(ForOUTTV)	WIRELESS
POWERIN	AUX IN	HDMI OUT
		(TV-ARC)

Bottom of the Soundbar

Attach the Toroidal ferrite core to the power cord of the Soundbar to help prevent RF interference from radio signals.

1.Pull the fixing tab of the Toroidal ferrite core to open it.

2.Make two loops in the Soundbar’s power cord.

3.Attach the Toroidal ferrite core to the Soundbar’s power cord as shown in the figure on the left, and then close it by pressing it until it clicks.

•• Ensure that the ferrite core is attached as close as possible to the power plug of the Soundbar.

ENG - 8