Samsung SWT10H2 CONTROL PANEL WASHING PROCEDURE

CONTROL PANEL WASHING PROCEDURE

SWT90C1(P)	/ SWT90C2(P)	(A)Type
SWT10H0(P)	/SWT10H1(P) /SWT10H2(P)

1.WATER SELECTOR

4.CYCLE SELECTOR

TO WASH

Before starting washing,	; Connect the water supply hose and open the water tap.
check the following	- Lay the drain hose down toward a sinkhole.(In case no drain pump)
	- Place the drain hose in sink or bath.(In case drain pump)
	- Connect the power cord to the power supply outlet .

During washing, WATER SELECTOR KNOB should be selected to wash. During spin rinsing, WATER SELECTOR KNOB should be selected to spin.

2.WASH TIMER

This is used to set the wash time, 1-15 minutes.

3.WASH SELECTOR

You can wash laundry effectively by various methods.

1 2 3

SW-903(P) (B)Type

1.WASH TIMER

This is used to set the wash time, 1-15 minutes.

This is used to set the Washing/Rinsing or Draining.

5.SPIN DRY TIMER

This is used to set the spin time 1-5 minutes.

45

4.WATER INTAKE

Connect water inlet to a tap with a suitable.

(A)Type

1.Set the CYCLE SELECTOR KNOB to ‘WASH.RINSE’.(in case drain pump ‘WASH’)

2.Set the WATER SELECTOR KNOB to WASH .

3. Select the

WASH SELECTOR KNOB for desired mode.

4. Fill water in the wash tub to the‘L1’ lower water level by carefully adjusting the tap water

(B)Type

1. Select the WASH CONTROL KNOB for desired mode.

2.Press the

DRAIN SELECTOR KNOB to ‘WASH’ .

3.Fill water in the wash tub

to the ‘L1’ lower water level by carefully adjusting the tap water and add the detergent.

4. Put the cloths into the wash tub and set the same water pressure

to fill the tub so as not to

2.WASH CONTROL

You can wash laundry effectively by various methods. 5. DRAIN SELCTOR

3.SPIN DRY TIMERBe sure to press the selector knob to ‘WASH’ while washing. This is used to set the spin time 1-5 minutes.

FRONT PANEL

REAR PANEL

and add the detergent.

5. Put the cloths into the wash tub and set the same water pressure to fill the tub so as not to exceed ‘H3’level.

6. Set the WASH TIMER

1-15minutes.

7. After washing, set the

CYCLE SELECTOR KNOB to ‘DRAIN’ for drain.

exceed ‘H3’level.

5. Set the WASH TIMER

1-15minutes.

6. After washing Press the DRAIN SELECTOR KNOB to ‘DRAIN’ for drain .

3 4