Unplug cleaner from electrical outlet.
Unplug cleaner from electrical outlet.
Place handle in Low position and turn vaccum cleaner over so bottom side is up.
Remove the eight screws as shown with a screwdriver.
Turn over the cleaner again, and lift the Cover-Brush off.
Remove the eight screws, and lift the Brush Cover off. Grasp Rotating Floor Brush at both ends and lift.
Clean strings, hair and other debris from Rotating Floor Brush, paying particular attention to brush ends.
Clean strings, hair and other debris from Motor Pulley and Drive Belt areas.
Check Drive Belt carefully for wear, cuts or stressed areas.
Maintenance
Check Rotating Floor Brush and Drive Belt
1
2
3
4
5
6
7
8
9
10 Check Air Passageway for obstructions. Remove debris from this area.
Replace Drive Belt
1
2 With Rotating Floor Brush removed from vaccum
3 Place new Drive Belt over motor pulley and stretch other end over rotating Floor Brush in the space between the bristles.
4 Place ends of rotating Floor Brush down into slots on sides as shown.
5 Turn rotating Floor Brush by hand several times in direction of motor pulley, if properly installed, Drive Belt will center itself.
6 Reposition Brush cover and eight screws. Tighten screws securely. Snap end of Brush cover into place.