CONNECTING THE WATER SUPPLY HOSE
1. Remove the adaptor | 5. Connect the other end of the water |
from the water | supply hose to the inlet water valve |
supply hose. | at the back of the washer. |
| Screw the hose clockwise all the |
| way in. |
2.First,using a "+" type screw driver, loosen the four screws on the adaptor.
Next,take the adaptor andturn part(b) following the arrow for gap about 5mm between them.
a
b
3.Connect adaptor to the water tap by tightening the screws firmly.
Then, turn part (b) following the arrow and put (a) and (b)together.
a
b
If the water tap is a screw type,assemble a water supply hose that fits to the tap as shown.
hose to the adaptor. Pull down the part (c) of the water supply hose .When the part (c)is released,
the hose is automatically cNOTICE After completing connection, if water leaks from the hose, then repeat the same steps.
Use the most conventional type of faucet for water supply. In case the faucet is square or too big,remove the spacing ring before inserting the faucet into the adaptor.
Lock
Lock Nut
UNLOCK LOCK
Adjustable
Leg
Unlock
●After slightly lifting up the machine, rotate the adjustable leg
UNLOCK LOCK
UNLOCK | LOCK | Lock | Unlock |
|
|
|
Adjustment of height
If not leveled, adjust the legs to level the washer.●Be careful not to put in your hand under the legs. (It may cause some injury)Pull the handles located at the right and left of the front side and slide off.Adjust the water drop mark to be in the red circle pulling back the machine slightly, and then, push it with a feet to fix.
Fix the handles by hand completely.8