INSTALLATION & MAINTENANCE
The UserÕs Manual is for common use.
Make use of the UserÕs Manual depending upon your washing machine model.
ENVIRONMENT
Leave some space
Maintain at least 10cm between the washer and the wall.
Place the washer on a sturdy flat surface.
If the washer is placed on an uneven or weak surface, noise or vibration occurs. (Allowable is 1˚)
Adjust the legs for even placement.
Never install the washer near water.
Do not place the washer in steamy rooms or where the washer is directly exposed to rain.Moisture may destroy the electrical insulation causing an electrical shock hazard.
Avoid direct sunlight or heaters.
As plastic and electrical components are affected by direct heat,never place the washer near furnaces, boilers, etc. Do not place under direct sunlight.
ASSEMBLING THE PRAT PROTECTION PANEL
Tilt the washer a little and lift up the panel until it clicks, finally fix the panel with screw to the base as shown in the figure.
Sisi belakang
1.Insert the sound absorbing panel to the assembling hole on back side to the end.
2.If you have difficulty inserting the panel lift up the washer a little and insert it
HOW TO ASSEMBLE THE LEGS
1. Check the 4 | Hook | |
| Hole | |
2. Lay down the Washing Machine to the front. | 2 | |
3. Insert the hook of leg in to the square hole | ||
1 | ||
of base. | Base | |
4. Push the leg to the arrow direction to “Click”. | ||
| ||
5. Finaly fix the legs on the base | Screw | |
with screw like a figure. | ||
|
IN CASE OF PUMP-DRAINED WASHER
Take out the
Be sure to join tightly the drain hose into the
Be sure to join tightly the drain hose into the
Install the drain hose in the position of about 70~80cm above the ground.
70~80cm
CONNECTING THE DRAIN HOSE
After pressing the joint ring(a), insert the drain hose(b) | (a) |
to drain direction. |
|
(b)
7